hansnl
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: They are just used for the front of 124016 ?
Asked by BG495160056 on 2022-12-29 12:03:14
hansnl I do agree with you , check tubo racing 1:76 at aliexpress.com nowadays. bye, Hans
Helpful (0)
hansnl I don't think this will work without adaptations of the inverter electronics.
Helpful (0)
Q: Can I externally control the frequency with a separate microcontroller?
Asked by TWYT on 2022-07-11 09:00:55
hansnl Yes you can, if your controller can output a analog voltage 0-10 volt or current 4-20mA VL1 External analog voltage input 0-5V 10V Analog voltage input CI External current signal input 4-20mA Current input
Helpful (0)
Q: Would this work with 1:10 scale Wltoys 104001?
Asked by BG511616532 on 2022-05-03 09:40:47
hansnl Yes, i do think so. My wltoys 144001 did have the same brushed motor like your 104001 , and this brushless kit fits fine even the 144001 has a smaller chassis. regards, Hans
Helpful (0)
Q: Is this compatible with EV8000D goggles?
Asked by BG521844312 on 2022-04-20 14:06:45
hansnl Yes, it is . Aswell for all other FPV receivers working at 5.8Ghz range.
Helpful (1)
Q: how do I set the parameters for a different transmitter if there is no 'set' button on the esc
Asked by EliotFox on 2022-04-06 04:13:19
hansnl The transmitter connects to the receiver with the BIND button in the receiver. The receiver (channel 2) is connected to the ESC . When you like to change ESC parameters, you have to order the available program card and connect this at your ESC . Hans
Helpful (0)
Q: does it come with reverse polarity protection ?
Asked by BG571654452 on 2022-03-23 09:51:41
hansnl Don't know but connect a diode anode at the red (+) wire and you reverse polarity protection. Succes !
Helpful (0)
hansnl For the rear axes also .. Tip: the chromed model are better rust resistant
Helpful (0)