All Messages

BG351738321 This one can not connect to App directly, you need a host, may be Boardlink RM Pro. Here's to a Great Day.

2022-02-08 01:20:53 Helpful (0)
Submit
Answers (2)

Q: Does this require a 5v source to power the RS485 side ?

Asked by ronklo on 2019-05-16 11:02:25

wujiahui This is not needed

2019-05-19 08:59:29 Helpful (1)
Submit
Answers (2)

isidoro The devices are for controlling the primary side of the transformer. The output (welding side as you say) depends of the transformer you will use. The transformer is not provided, you need to buy or make your own transformer. If you don't know this things maybe this project is very dangerous and not recommended to you.

2020-04-05 10:33:56 Helpful (1)
Submit
Answers (2)

Q: Is it compatible with LTN156AT27-H02?

Asked by Sitalkas on 2020-05-26 01:43:44

ronklo It should be compatible. The LTN is a fairly common resolution screen (1366x768). I have other model screens at this resolution and they work fine. You just need to flash this board with the correct firmware for that resolution. Instructions are in the listing for programming it.

2020-05-28 08:22:03 Helpful (0)
Submit
Answers (1)

Conatus https://www.banggood.com/VHM-004-XH-M604-Battery-Charger-Control-Module-DC-6-60V-Charging-Control-Switch-Protection-Board-for-12V-24V-36V-p-1526823.html

2020-04-15 01:47:14 Helpful (0)
Submit
Answers (1)

justashish1 Yes it’s very easy, you need sonoff RF to work with it, just press the sonoff RF switch till the light blink red and press the button, this will link the switch

2020-02-03 01:28:58 Helpful (0)
Submit
Answers (1)

Q: Is there any way to set these to always start in flame mode?

Asked by ronklo on 2019-11-10 08:20:07

Blithe You can change the lighting modes by the switch.

2019-12-02 08:56:36 Helpful (0)
Submit
Answers (1)