All Messages

SonOfYorkie 08/05/2021
Its arrived. reccomend to strip it and re build it. 1 lipo was plugged into esc this one took 6to8 hours trickle charge and balance but it's ok now. the other was not connected and fully balanced in around 90mins fairly standard. they should of been at storage level for that time and NOT plugged in. fire risk?! I had to tun it once pre strip but who wouldn't right? glad I did its awesome. pinion and spur were not meshed correctly with a sheet of paper they were hard up I'm sure. fluids included in shocks - None fluid included in diffs - Vaseline perhaps? thread lock incuded - on major screws I think it was hard to say. so post strip and rebuild it's much the same in the way it runs, less baggy and tighter, but same speeds. I have peace of mind it's going to last untill the next service and strip in 10 runs or so if I'm going to make it last and not run it into the ground which you will do with any RC car no matter what car you must strip them clean them lubricate etc. the main difference is when I crash it and break say a suspension arm will I get replacements like I can my arrma and traxxas cars. so in te last 18 months I've pick up the following arrma cars, Senton 3s, Big Rock 3s, Notorious 6s, Felony 6s, Outcast 8s, I've also got a traxxas maxx. So in comparison to all my others it's on a par with the felony fun factor wise, the hoonigan turns more heads, especially at night. it looks stunning. For any Mid to Serious RC enthusiast this car is a must it's so beautiful and fun to drive. I'll be getting a bare one for spares now. when it finally dies it's going to look awesome on the wall in replacement of a painting next to the Felony. For the record I've had to go over all my cars to tighten screws ect, none have been perfect. none. I've broken all of them eventually, never the cars fault always mine, if you drive em like you stole em your gonna break em. Just waiting for a ZD racing no prep drag car now. Come on ZD where is it??
27
Recommendations
Comments (3)

SonOfYorkie was there supposed to be a rubber grommet inside the drive shaft cup that has fallen out, all my arrma and traxxas have a rubber or composite grommet in the cup. I'm awaiting delivery of mine, just trying to get parts lined up so I can mod and run when I get it. any other mods you reccomend, I've got a servo, esc and motor ready. hope I wont need but it's going racing with my felony! thank you. enjoy

IVIegadork 03/04/2021
17
Comments (14)

SonOfYorkie looking good.... can we have some more pics please! thanks a million.

Rune Krosser 31/03/2021
6
Comments (2)

Jarrod22 All screws on the splint needs to be removed,be careful to take them apart,then you can open the outer cover

2021-03-23 01:20:26 Helpful (0)
Submit
Answers (1)

Q: Quantos motores? O leme usar servo?

Asked by Lauro Azuaga on 2019-08-26 12:10:56

BG115294912 3x motors. unsure of servo type.

2021-03-12 06:40:23 Helpful (0)
Submit
Answers (1)

Q: Does this come with a glacier?

Asked by dudeman on 2019-12-03 02:19:20

BG115294912 no glacier it would melt

2021-03-12 06:38:30 Helpful (0)
Submit
Answers (5)