All Messages

Q: it cans work all thr time? or only sensor?

Asked by Tal Stern on 2020-07-06 03:59:43

lilraptor40000 If you notice on the picture just below the sensor is a little button. The first press is sensor operation. The second is always on, but with reduced lumens (brightness). The battery will not last all that long like this and probably the reason for the reduced lumens. I tested it lasting about 3-6 hours depending on the light it received during the day.

2020-09-09 11:46:31 Helpful (0)
Submit
Answers (3)

Q: can this be used for ender 3 v2?

Asked by tocatech on 2020-06-08 01:44:41

lilraptor40000 I can verify the metal extruder will work with the Ender 3 V2, but the springs will not without setting your Z axis offset by at least 10mm. Fully compressed the springs together with the new glass bed are 9.86mm too high. The silicone hot end caps fit just fine even though the V2 comes with them already. The tubing is standard and works just fine. The springs are the only incompatible item in the set.

2020-08-24 03:12:55 Helpful (2)
Submit
Answers (4)

Q: will this fit the Ender3 Pro

Asked by Brad on 2019-07-22 11:21:01

lilraptor40000 I can verify the metal extruder will work with the Ender 3 V2, but the springs will not without setting your Z axis offset by at least 10mm. Fully compressed the springs together with the new glass bed are 9.86mm too high. The silicone hot end caps fit just fine even though the V2 comes with them already. The tubing is standard and works just fine. The springs are the only incompatible item in the set.

2020-08-24 03:09:06 Helpful (0)
Submit
Answers (7)