All Messages

LiorAlbaz the file format store in the SD is *.prv (not *.avi) so you can't be play it normally with a PC. you have to use the app or the build-in player to see the video. maybe there is a file convertor.

2021-12-21 08:13:37 Helpful (1)
Submit
Answers (2)

LiorAlbaz maybe different sticker with extra cost ? :-) I would goes on the original UTI260B and not hassle with rebadged product.

2021-11-24 02:40:59 Helpful (8)
Submit
Answers (8)

Thor0001 YesI have found the need for Wifi and APP. In any case, emg automation happens from there if you do it there. You should use ewelink independent software eg home assistant for automation and you will not depend

2021-10-25 10:50:51 Helpful (0)
Submit
Answers (1)

Q: Does it support WEB like Chrome or IE ?

Asked by LiorAlbaz on 2020-10-25 06:55:57

weedhopper NO !!!! Flash Player is still needed (Today Flash Player is not available and not recommended...)

2021-08-19 06:18:08 Helpful (0)
Submit
Answers (2)

Q: Do you have it in 3 phase ?

Asked by LiorAlbaz on 2020-12-13 06:54:48

wuchuangbin You can consult online customer service

2021-01-04 08:33:45 Helpful (0)
Submit
Answers (1)

Q: Can it switch on every 3 hours for 1 minute.. For egg turner motor?

Asked by George Nieuwoudt on 2018-12-23 12:47:20

LiorAlbaz Yes. min step is 1 minute. and you have 16 programs. so you can do: 1: ON:00:00 OFF:00:01 (all week) 2: ON:03:00 OFF:03:01 (all week) ....... if you need less then 60 second you should get one with "PULSE" mode. In PULSE mode you can set pulse width (e.g., 10 sec) and have 16 programs 1:00:00 (all week) 2:03:00 (all week) .......

2020-12-13 05:13:54 Helpful (0)
Submit
Answers (1)

LiorAlbaz measuring DC current with clamp always have some DC offset. if you have compatible voltmeter you can do it automatically by press the REL. if not, just write down the value before start the measurement (- or +) and add to your measurements.

2020-11-13 04:59:54 Helpful (0)
Submit
Answers (2)

Xuthus If you have questions, you can send an email for customer service help

2020-11-02 04:29:45 Helpful (1)
Submit
Answers (1)

Q: will this work with nightowl wireless camera?

Asked by BG101054346 on 2020-08-07 01:52:05

LiorAlbaz It work with any IPC ONVIF version 1.6 or 1.2. BUT the "smartness" of this device found in the IPC using SLINK so no SMART features ! Motion support only if IPC supported - and I have a few issues with that - it stop receive motion event form IPC from time to time.

2020-10-25 06:55:05 Helpful (1)
Submit
Answers (2)

Q: its a 16ch??

Asked by Jorge Manuel Bação on 2020-09-16 03:01:00

LiorAlbaz Default is 8. Go to device configuration and change to 8 or 16 mode. then it will restart.

2020-10-25 06:52:10 Helpful (0)
Submit
Answers (2)