NoCookies
NoCookies Use Impulse RC driver fixer to put FC into DFU/Boot mode. You may need to try more than once to get DFU mode. Once in DFU you can flash back to normal using correct target.
NoCookies D gains need to come down a bit and the camera needs hot glue
NoCookies I wouldn't doubt it was pre production they sent you. Seems the production model has black tails instead of the white on yours.
NoCookies Mine came perfect condition and I love how it's much more stable with little to no gyro drift. All the cloned boards seem to have lots of issues out of the box or after some hours of use. Make sure to save a dump of your configurations every time BF is updated. Reassigning resources is real important for this fc board as the default betaflight resources do not match the board's output. Hope that wasn't confusing. As gruntled stated, directions are there if you need them.
NoCookies 6 wire output to connect to 4in1 ESC. This is not entirely accurate because I've had signal and power wires reversed but most of them are wired this way. Positive, Ground and signal wires for the 4 motors.
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
