All Messages

tjones99 03/01/2019
Just arrived, have done minimal testing. Image quality looks good. App view starts in 640 resolution which some complain about. Really easy to switch to 1080p and get good quality. Not a real issue in my opinion. It acts like a wifi access point (hotspot) to connect to initially to configure it for your wifi network. One disappointment I have is there does not seem to be a way to set a password for AP mode so if you have not configured your network or if the configured network is unavailable then the camera will generate an open wifi network. there is still a device password that is set to prevent access but that is easily reset with a long press of the reset button. I would have lied to be able to just have each camera act like a secure hotspot so that it could be used directly. It can if you trust the password protection. Not sure I do yet. I was a bit surprised when the ordered white version arrived, the mount and the cable that comes with the white version are black. Minor issue but I would have preferred all white. The instruction sheet provides a QR code to quickly download the app. iPhone app comes from App Store. The unit is much smaller than I expected (in spite of the accurate images showing it in someone's hand) it comes with a short micro USB charge/power cable (1m) and a STIFF 10cm micro USB cable. The latter could be used to operate the camera plugged directly into a USB power adaptor. No power adaptor is provided with the unit. The unit powered on immediately via its built in battery. I have not had it long enough to see how long it will last on battery but I do not intend to use it that way. The swivel base has a swivel end that has a metal plate that the magnet on the back of the camera can stick to. the swivel end also has double sided tape for a more permanent attachment. the other end has double sided tape to stick to a surface.
6
Recommendations
Comments (1)

LFANS2001 These are broken tap removing tools. When you brake a tap on a 10mm jammed screw you must use the #10 tool

2020-11-18 02:14:27 Helpful (0)
Submit
Answers (3)

Q: How many channels?

Asked by tjones99 on 2018-10-29 10:54:54

wangshuinong 7ch

2018-11-05 01:05:06 Helpful (0)
Submit
Answers (1)

Haven The 3D Printer only supports sd card offline printing.

2018-10-08 03:13:19 Helpful (0)
Submit
Answers (1)
tjones99 26/02/2018
0
Recommendations
Comments (0)