Donald
Q: Is this a collective pitch or fixed pitch helicopter?
Asked by Donald on 2024-04-02 04:33:42
locsanjose collective pitch
2024-04-03 09:28:33 Helpful (0)Q: I need the motor mounts to be 16x19mm. Is that what this is or is it 19x25mm?
Asked by Donald on 2019-09-02 10:17:00
Mesut Özer böyle beklemiyordum
2024-03-27 08:25:39 Helpful (0)Q: I thought this was a VTOL aircraft. Is it only fixed wing, and not VTOL?
Asked by Donald on 2023-12-02 06:23:13
BG391735534 this ad is fixed wing, but you can buy the kit vtol
2024-03-15 05:42:35 Helpful (0)Q: What is the radiation hazard from the radioactive luminous handle?
Asked by Donald on 2020-10-31 07:50:11
raivis11 its not radioactive.. its just reflecting light, nothing else
2022-02-06 11:58:10 Helpful (1)
AviationAddict The blunt edge of the propeller is the direction it turns when looking directly at the propeller from the front for a fixed wing, or from the top for a quad-copter.
2024-01-13 04:55:11 Helpful (1)Q: Does the PNP version offered here include a camera?
Asked by Donald on 2023-12-02 07:28:06
Minepl no
2023-12-20 03:09:14 Helpful (0)Q: Is the P-51 Mustang motor brushless or brushed?
Asked by Donald on 2023-12-02 07:05:07
GRW161576thstsw Regular brushed
2023-12-04 07:52:04 Helpful (0)Q: Are the shank sizes 4mm or 1/4in?
Asked by Donald on 2018-09-09 08:07:56
Sujay Das battery conjunction too high but too good
2023-10-21 08:21:16 Helpful (0)
Donald Watts are Volts time Amps pulled. To answer your question you need to provide the battery voltage you will use and the load, i.e. the prop diameter and pitch, and its expected amp draw. Of course the retailer should have already provided a chart with the recommended props for the voltages this motor can handle. Since they don't, it's up to you to guess that and hope you're right!
2023-09-25 04:07:57 Helpful (1)Q: On the pictures I see three black cables. How do I identify the polarity of them?
Asked by Franko on 2021-05-12 05:57:10
Donald Brushless motors wires do not have polarity like brushed motors. The 3 wires alternately pulse each set of magnets inside the motor acting more like AC current, not DC current. As already mentioned, swapping any 2 of the 3 wires changes direction of the motor. Some ESC programmers can also do that without changing wires.
2023-09-25 03:57:38 Helpful (1)
Donald Most BL motors can spin in either direction by changing any 2 of the 3 wires powering it. But if the motor spins the same direction as the prop nut, the nut will eventually spin itself off the prop shaft unless you use a Nyloc nut or secure the nut after it's on so that it cannot move unless you remove the wire or the clevis pin. Some use a second nut over the first but a liquid like Locktite should be used in that case.
2023-09-25 03:39:49 Helpful (1)Q: Can I use a 6s batterie with this motor?
Asked by ismaelbiber on 2020-09-19 06:06:30
Donald The specs only show up to 4S. You will most likely burn up the motor is you use a battery higher than 4 cells.
2023-09-20 04:27:25 Helpful (1)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
