stevietee10
Q: Is this camera with which you can record flight and later watch or you need FPV googles?
Asked by BG163311359 on 2022-01-26 06:05:42
stevietee10 You need goggles or a monitor to view this camera, usually with video transmitter and receiver system. It does not record but you could add a video recorder board which would save video to an SD card
2022-01-26 08:13:31 Helpful (0)Q: Will a 4s 5000mah lipo fit in this?
Asked by BATAN on 2021-10-15 01:17:13
stevietee10 YES, a Turnigy Multistar 4S 5200mAh, the green one :-), fits perfectly in the S1100 front battery bay.
2021-10-22 07:08:08 Helpful (0)Q: can i use it with a flysky transmiter?
Asked by BG454817151 on 2021-09-19 01:15:25
stevietee10 Yes, just use a radio receiver that is compatible with your transmitter 🙂
2021-09-19 02:31:58 Helpful (0)
stevietee10 Yes, same battery, has a link harness to share battery between goggles and receiver bay. It works well 🙂
2021-04-08 12:34:51 Helpful (0)Q: how many device can we operate by this remote at a time?
Asked by Nawab Ahmed on 2021-03-29 11:27:20
stevietee10 Four (4)
2021-03-30 12:16:19 Helpful (0)Q: Funciona com DJI NAZA / DJI Wookong / DJI A2?
Asked by rodrigao2010 on 2021-02-20 08:53:04
stevietee10 No, this will not work with DJI controllers DJI use a single proprietary serial connection for both GPS and compass. This BN-180 unit only has a GPS outputting a raw serial data stream, no compass
2021-02-21 04:10:01 Helpful (0)Q: does battery come with saw?
Asked by BG422452839 on 2021-02-12 02:05:15
stevietee10 No it does not.
2021-02-13 12:07:32 Helpful (1)Q: Hello. what are the plastic lenses tucked over the lenses for? can they be removed?
Asked by lalaleonardo on 2020-12-07 12:40:50
stevietee10 These are blank plastic lens protectors, if you wear glasses they can be replaced by 'prescription lenses' for super sharp image Hope this helps, Steve.
2020-12-07 01:27:56 Helpful (0)
Q: Are the stickers water slide or peel and stick?
Asked by Harold on 2020-11-04 08:02:57
stevietee10 Peel and stick 🙂
2020-11-05 12:05:24 Helpful (1)Q: can i use this for back up battery for my motorcycle 12v battery?
Asked by BG203854573 on 2020-10-11 02:47:33
stevietee10 NO! NO! NO! This is not a battery, it produces very high voltage which can cause severe pain or injury to a person This is what is used in cattle prods and Tazer guns !!!
2020-10-11 04:32:41 Helpful (3)Q: has any one tested on 5v or is everyone just running 3.3v
Asked by crash0ne on 2019-09-08 10:40:52
stevietee10 Power it from 5v, it has an internal 3.3v regulator for the components that need 3.3v
2020-09-29 02:13:10 Helpful (0)Q: Can it work with F765 ardupilot?
Asked by salim al:amri on 2020-08-30 07:30:43
stevietee10 Yes, works with Matek F765 flight controller.
2020-09-29 02:11:01 Helpful (1)Q: HI Friend is compative in 1.2 ghz ? What the best antena for 60 km alcance?
Asked by BG525162817 on 2020-08-23 02:46:49
stevietee10 YES it is compatible with 1.2GHz use Just install the antenna suitable for your needs. I’m using mine with 2.4GHz, others are using 5.8GHZ. Just depends on your choice
2020-09-29 02:01:50 Helpful (1)Q: does it fit pixhawk FC? does it have the 6 pin connection as well as the power connector?
Asked by Yaniv Yacoel on 2018-12-23 01:08:07
stevietee10 This will work with PIXHAWK, it has 2 wires for power, 2 wires for GPS TX/RX and 2 wires for magnetometer (compass) SCL/SDA
2018-12-30 04:35:08 Helpful (0)Q: What magnometer does it use? Need to select it in iNav / Betaflight?
Asked by mikiefpv on 2018-10-29 08:01:54
stevietee10 HMC5883, in Betaflight / iNav select 'MAG Alignment' at CW 270' Flip
2018-12-14 04:03:43 Helpful (2)
stevietee10 Agreed, Mine also had wires reversed in connector, bought May 2018, TAKE CARE ! (fortunately unit was not damaged) Steve
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
stevietee10 Yes, to change direction of rotation just reverse (swap) any two motor wires, any two, doesn’t matter which 😀
2022-05-23 09:11:47 Helpful (0)