All Messages

Shmuel Goodreview. Could you please help me find the same set with Left Hand Thread? I am in urgent need of such a kit. You may answer me directly through WhatsApp 230 5837 6809. Thanks and Regards. Sham,

ckovoor 19/02/2022
Disclaimer: I received this set for evaluation from Banggood, and did not have to pay for it. However I have tried to be impartial in my judgement of these bits. Features: The set of 12 tap drills, 6 each in Metric and SAE sizes, comes with a bit holder which enables quick changes on your drill. The bit holder has a spring loaded catch which holds the drill bit once it is inserted. To release the bit you have to pull back on the ring. I found this to be a very practical feature. The Metric bits in my set seem to have a yellow coating on them, but the SAE bits do not come with any such coating. The set comes in a well made, sturdy plastic case, with good hinges and a sliding lock, all built to last. The bits and the case arrived undamaged, and without a hint of rust or dent damage. This was so even though a couple of the bits worked themselves loose from their cylindrical holders within the case. Usage: I have tried the bits out on Aluminium sheet, upto 4 mm thick, and also Aluminium rod, upto 25 mm in diameter, as well as Acrylic sheet. In all cases, the bits cut well, and the tapped threads were formed well too. With Aluminium I used WD-40 as a cutting lubricant, to increase the life of the bits and to control "sticking". I have not yet experimented with mild steel, but the bits look good enough to tackle at least thin sheet upto say 2 mm in thickness. I also used it on acrylic sheet and there too the results were decent. I note that other reviewers speak of using it on 3-d printed parts (PLA/PETG/ABS plastic), and I would imagine that to be an excellent application for this set. Overall: Overall, I think these are good value for money and a recommended addition to any workshop.
5
Comments (2)

Q: What is the supply voltage to those tips?

Asked by Shmuel on 2024-01-28 04:47:25

The seller Both 110v and 220V are suitable.

2024-01-29 11:49:37 Helpful (0)
Submit
Answers (1)

Q: Nihao. Can this BMS be used for 20+ volts cordless drills?

Asked by Shmuel on 2023-08-21 12:13:31

WayJJJJ 21.6V (rated voltage of polymer battery) , 22.2V (rated voltage of 18650 or 3.7V lithium battery) , 25.2V (voltage after the lithium battery is fully charged) , Discharge 22A (refers to the upper limit discharge current limit)

2023-08-21 01:51:04 Helpful (0)
Submit
Answers (1)

Shmuel Iam waiting for delivery. I intend to use a 18650 Li-Ion cell through a 5 volt boost converter and current will be more than enough.

BG183217573 13/03/2019
4
Comments (1)