All Messages

Q: will this work on the occ swhinn chopper stingray

Asked by southwest7mile on 2019-01-07 02:31:24

databanks Ifthe stingray has a standard bike rear wheel then you should be fine. Looking at photos, it seems to, but obviously a photo does tell me what the hub dimensions are (sorry). With that in mind, if you've ever seen one with one of those little 2-stroke gasoline motors then that's what these gears are designed for. Nice bike, btw. Pretty sure Atomic Zombie took some inspiration from them with some of their chopper projects

2019-06-06 07:24:05 Helpful (0)
Submit
Answers (5)

databanks Theconcept is great, isn't it? The only issue I've had with my set is some of the smaller bits coming apart - the hex base and the drillbit were only glued in and even drilling plywood was enough to pull them apart under the light strain

Lagger 08/01/2019
0
Comments (2)

databanks Ineed to make an update. It seems some of the smaller sizes aren't stuck together very well. The after just 5-6 holes drilled into simple plywood, the hex base and the drill are separating. Looking inside the hole in the hex section, it seems they're just glued in and the glue fractures fairly quickly with light use. I'm going to attempt to solder them in at a later date

databanks 19/11/2018
0
Comments (2)

databanks Indeed, this is for taking heat away using water and external radiators with fans as you'd use for water cooling a CPU. It does give me some ideas for water blocks and water loops on both sides that could be used for cooling the water coming from my taps (often hotter than the water from the hot water tap due to some really stupid plumbing by the owner)

2019-01-24 01:29:29 Helpful (0)
Submit
Answers (5)