satishkbg
My Contents
All Messages
Reviews
Comments
Answers
Questions

All Messages

Tarot 450 PRO Flybarless System Metal Head Rotor Black TL45110-01
US$24.33 US$33.99

Q: Is the washout-base shown here molded into the head housing or is it separate - cannot tell from the picture

Asked by satishkbg on 2020-06-09 04:07:53

Tracy separate

2020-07-05 09:41:08 Helpful (0)
Submit
Answers (1)
Micro 20x20mm Betaflight Omnibus STM32F4 F4 Flight Controller Built-in BEC OSD for RC FPV Racing Drone
US$20.89 US$28.99

Q: can we flash iNav on this?

Asked by satishkbg on 2019-10-09 12:56:56

Dave fora wing maybe but for a quad there is no baro or SDA SCL connections for a compass or a spare uart for a gps, so I would get another FC

2020-04-29 10:26:36 Helpful (0)
Submit
Answers (1)
iRangeX IRX4 2.4G CC2500 NRF24L01 A7105 CYRF6936 4 IN 1 Multiprotocol ARM TX Module With Case
US$39.59 US$62.99

Q: Does work with ER9X firmware?

Asked by satishkbg on 2019-09-11 01:55:19

Adrian Tan Kar Yin Yes it appears it will work with ER9X firmware as can be seen from this Youtube video - www.youtube.com/watch?v=BY_8xK5cfbE

2019-09-11 04:12:51 Helpful (0)
Submit
Answers (1)
satishkbg 07/01/2019
Using this for programming my Turnigy 9X Tx, and it works perfectly. Use the zadig tool to download the appropriate win32 drivers after connecting to USB. Thanks BG.
5V Micro USB Tiny AVR ISP ATtiny44 USBTinyISP Programmer Geekcreit for Arduino - products that work with official Arduino boards
US$4.39 US$10.99
0
Recommendations
Comments (1)
satishkbg 14/07/2019
Fast and accurate, small form factor, much smaller than expected.
ALZRC Devil 380 420 480 X360 Parts 452MG 450 CCPM Mini Digital Metal Servo
US$33.07 US$43.99
0
Recommendations
Comments (0)
satishkbg 14/07/2019
Good performance - using it on FBL Heli for powering the servos.
External BEC UBEC 5A 5V-30V Receiver Power Supply
US$10.82 US$14.39
0
Recommendations
Comments (0)
satishkbg 14/07/2019
Smaller than i expected, this rx is of top quality build components. Using it on my quad with Turnigy 9X V2 and it binds perfectly. I haven't checked the range yet. The size really is amazing for micro builds and where you need PPM with old TX's.
iRangeX Tiny 2.4G 6CH Flysky Receiver Compatible with Flysky PPM Output for Eachine QX80 QX90 QX95
US$8.51 US$14.99
0
Recommendations
Comments (0)
satishkbg 26/12/2018
Very small form-factor, perfect for mini/micro builds. Took a while for initial fix on a cold start, but after that it's very fast getting a 3d fix, even indoors it sees about 5-8 sats. Very satisfied with it's performance so far.
BN-200 Small Size M8030 Chipset GPS Module Antenna GPS GLONASS Dual GNSS Module With 4M FLASH 20mmx20mmx6mm
US$10.82 US$20.99
1
Recommendations
Comments (1)
satishkbg 21/11/2018
Just perfect for mini and micro drone builds. Excellent receivers.
2.4G Satellite Receiver For DSM2 DSMX JR Spektrum transmitter
US$16.01 US$22.99
0
Recommendations
Comments (0)
satishkbg 21/11/2018
Great value F4 AIO from BG. Has everything you want from a F4, good quality solder, solder points, excellent feel. Pretty easy to get going. I use the BG DSMX Satellites from the 3 pin port which supply the required 3.3v. Can power it directly from a lipo, which is excellent to save weight of PDB's. Also has a onboard OSD which is pretty good. Comes with baro, but i have never been able to see it work as BF/CF simply dont detect it. iNAV seemsto detect it but i'm not a great fan of iNAV. It doesnt have any voltage/current sensor, so that's a missing feature. Probably best suited for racing drones. Right now i have it on one of mine.
Omnibus F4 Pro V3 Betaflight Flight Controller Built-in OSD Barometer SD Blackbox for RC Drone
US$26.49 US$32.99
0
Recommendations
Comments (1)
satishkbg 21/11/2018
Needed these for my old zmr clone, and it does the job. Thanks BG for stocking these.
QAV250 ZMR250 RC250 H250 250mm Series Frame Aluminum Column Screw Kit for RC Drone FPV Racing
US$5.79 US$5.22
0
Recommendations
Comments (0)
satishkbg 21/11/2018
This still seems to be my safe choice for all my autopilot builds, as it's wide support from external devices and firmware. I have one of this with ardupilot and it works pretty well. Still testing, will post some feedback when done.
OpenPilot CC3D Revolution Revo 10DOF STM32F4 Flight Controller Staight Pin for RC Drone FPV Racing Multi Rotor
US$58.87 US$56.95
1
Recommendations
Comments (0)
satishkbg 21/11/2018
This was my first OSD and it's still out there. Iprefer this over the micro minim when it come to the solder pads/joints, it's strong and reliable unlike the micro minim osd's which easily come off. Always suggest to do the solder bridge for 5v mod.
Mini OSD Module for APM Pixhawk Pixhack Flight Controller Board
US$11.47 US$20.99
0
Recommendations
Comments (0)
satishkbg 21/11/2018
Probably best quality PPM+PWM Rx in market. The build quality is excellent and binds without any issues with my Devo 10 DSMX. The pins are a bit confusing with the sticker, else no issues. Will be buying more of these.
iRangeX RM601 2.4G 7CH Micro DSM2 DSMX Compatible Receiver With PPM Output
US$25.07 US$29.99
0
Recommendations
Comments (0)
satishkbg 21/11/2018
Have 2 of these, probably the easiest autopilot FC to setup. Board qaulity seems ok if no the highest. Comes with all necessary connecting cables which are of good quality and an antenna for the OpLink. There's also a piece of foam covering the baro, which is good. But i use it out of case so had to put my own foam covering. There is some amount of heat from the regulators on-board. Easy to setup GPS and MAG and power sensor, with just enough ports.
OpenPilot CC3D Revolution Revo 10DOF STM32F4 Flight Controller Staight Pin for RC Drone FPV Racing Multi Rotor
US$58.87 US$56.95
1
Recommendations
Comments (0)
satishkbg 21/11/2018
Nice little Rx very easy to setup and bids perfectly with my Devo 10 and deviation Tx and Omnibus Pro. 3.3v input.
2.4G Satellite Receiver For DSM2 DSMX JR Spektrum transmitter
US$16.01 US$22.99
0
Recommendations
Comments (0)
Matek F405-STD BetaFlight STM32F405 Flight Controller Built-in OSD Inverter for RC Multirotor FPV Racing Drone
US$54.99 US$55.99

Q: Can we use a spektrum/compatible DSM2 receiver with this? which ports do ch1,2,3,4 etc go into on this board?

Asked by satishkbg on 2018-05-07 01:22:22

wangshuinong yes, you can see this link(BF wring this place): http://www.mateksys.com/?portfolio=f405-std#tab-id-3

2018-05-18 04:48:12 Helpful (0)
Submit
Answers (1)

You are the expert,can you help?

We sincerely invite you to subscribe to the Invite Answer email!

If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.

Help others and be happier!

  • Subscribe

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.Specific people will also have their own exclusive badge.
CEO Badge

The CEO Badge is owned only by the boss of Banggood.

Badges you can earn are coming soon
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe