Customer Reviews

4.91 out of 5
See all 1090 reviews
Write a Review
  • All Reviews (1090)
  • Image (133)
  • Video (3)
  • All Star
    • All Star(1090)
    • 5 Star(1017)
    • 4 Star(60)
    • 3 Star(7)
    • 2 Star(2)
    • 1 Star(4)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (Australia)
Show Original

A part of the review has been auto-translated.

  • 27/07/2020

    I got this multimeter for basic repairs when my profi amprobe multimeter just isn't good enough and I need to see oscilloscope. Voltage, freq and duty cycle work great with absolute accuracy. Resistance and capacity is also measured exactly, But amperes have cca 1% error, so that's not great and not terrible. The test leads howerer won't withstand 10A, they get really hot, I recommend buying better leads. mA measurement is accurate. Multimeter has HOLD function with small window that shows actual value. P-H mode can be started or stopped and records max and min. REL mode does offset and tells you the offset value at the bottom. These are very handy functions. Range is default auto, but can be set manually. Oscilloscope function works well and has functions like Vp-p, Vrms, Vavg, Hz, +Vp, -Vp and duty cycle just at the bottom of the screen. It has trigger with rising/fading, auto/single/normal and level settings. Volt/div and tim/div can be manually adjusted. It also has autoset. If you press hold, you can use V and T cursors or store it. Memory for scope images and multimeter values comes handy, but can't be exported unfortunately. What manual does not say that if you turn it on while holfing F4, it goes in silent mode. LCD screen is just basic, with poor viewing angles, but resolution is good enough. It comes with soft pouch, leads, temp sensor and manual I really needed to have read to access all the functions. I recommend this product

    Comments (4)
    Show Original
  • 10/10/2019

    the meter comes with an impressive array of features at a modest price but there a couple of issues I found for which I am not sure if they are specific to the unit I received or they are all like this - when measuring AC volts it shows 5.1mV even with the probes shorted (see pic). This makes it unsuitable for measuring low voltage AC - in oscilloscope, it is not possible to enter the cursor measurement mode. The option CURS (F4) described in the manual does not appear after holding the waveform or using single triggering. Therefore the cursor functionality cannot be used at all Other than that it is a decent all around instrument and a value for money especially when on promotion

    Comments (6)
    Show Original
  • 12/02/2020

    The item was well packed and arrived without any damage. I made some quick tests. Tested the scope function with 10 kHz and 10 MHz square signal. At 10 MHz it have larger distorsion compared to a Hantek 2D72 scope. The sine shape is acceptable at 25MHz and good at 5MHz. The voltmeter tested with LT1021CCN8 5V and 10V voltage references. The measured values are in the tolerance of the reference ICs. The instrument sucks the batteries so it is recomended to use rechargeable ones. The quiet mode is not documented. To reach it press F4 while turn on. It not stored so you have to do it every time when turn it on.

    Comments (1)
    Show Original
  • 26/04/2021

    Product corresponds to the description. Quality is very good. Works excellent and without problems. Am satisfied with this product. Measuring accuracy is really tip. A very good device for a small price. I tested it in our electronics laboratory. Are convinced of this device. Can recommend it with calm conscience.

    Comments (3)
    Show Original
  • 16/12/2019

    The Oscilloscope is a lot better than the MT8206 indeed: Far better picture, huge increase in frequency range. I connected to Danui FY3200S signal generator and parallel my old Dynatek (CRT) scope. MT8206 barely showed 50 kHz, where MDS8207 got to 24 MHz - although I did need to increase output voltage (not sure if this is signal generator, cables or 2 scopes in parallel).

    Comments (1)
    Show Original
  • 03/03/2020

    It's a great measuring device. In one device, a multimeter, excellent features, and an OSCILLOSCOP that meets the most common need for a graphic display of signals. Simple to use. Price/Quality ratio at the highest level. My sincere recommendation. It stays in my measuring devices forever.

    Show Original
  • 21/10/2019

    Banggood çok iyi bir site siparişi verdiğim anda kargoya verildi tek sorun türkiyedeki ptt kargoda çıktı neyse herkese tavsiye ederim ayrıca Ürün gerçekten kaliteli harika bir cihaz herşey anlatıldığı gibi daha menü ve özelliklerini çözemedim ama sanırım biraz kurcalayarak öğrenirim ayrıca youtube da yabancı kullanıcıların tanıtım ve test videoları mevcut keşke türkçe video da olsaydı en azından alt yazı desteği olabilirdi teşekkürler banggood

    Comments (3)
    Show Original
  • 22/05/2021

    This is an excellent multimeter. Very accurate, I measured with calibrated sources and the readings (volts and Ohms) were spot on. The oscilloscope is a dream. For an amateur hobbyist is perfect and also very accurate. The slots for testing transistors is a little tricky. You may think it is not working at first but it takes a bit of fiddling until all 3 pins sit correctly for the meter to give you a reading. Other than that, I think the best MM/Oscilloscope for the lowest price.

    Show Original
  • 24/09/2020

    I've been using this product for a couple of weeks now. It was delivered in a cardboard box that was damaged during transport, but it's contents were fine. The multi-meter itself comes with a protective bag that is only just large enough to fit the multi-meter and it's accessories. It isn't the fastest multi-meter around, but it certainly isn't slow and the probes are not the best, but certainly not the worst I've seen. The same can't be said for the temperature probe, which feels flimsy and is far from accurate. The oscilloscope functionality obviously doesn't compare to a desk oscilloscope, but is good enough to validate simple signals in the field. I'm happy with this product for my hobby and feel like the quality is what one could expect for this price point.

    Show Original
  • 27/10/2019

    Muito bom. Multitester+osciloscópio 2em1. Tamanho pequeno. Boa qualidade. Boa ferramenta para mim. Muito útil.

    Show Original

    Total 0 pages

    Go to page


    You might be interested in

    recommendation for you
    • US$11.72
    • US$22.74
    • US$29.99
    • US$12.99
    • US$46.99
    • US$9.99
    • US$209.99
    • US$134.99
    • US$23.99
    • US$40.69
    • US$46.99
    • US$25.99
    • US$9.99
    • US$24.99
    • US$17.99
    • US$12.49
    • US$8.99
    • US$42.99