The case makes a good impressuon but it does NOT FIT WITH THE FIXED HANDLE. (No chance!) Also there is no protection for the gimbals at all. Not agains pressure nor ratteling araund. Same problem whe trying the TX16S. This might also fit without the handle but there are two thinigies for the fingers on the backside of it the might be a problem. I don't want to remove them just for trying out.

The case makes a good impressuon but it does NOT FIT WITH THE FIXED HANDLE. (No chance!) Also there is no protection for the gimbals at all. Not agains pressure nor ratteling araund. Same problem whe trying the TX16S. This might also fit without the handle but there are two thinigies for the fingers on the backside of it the might be a problem. I don't want to remove them just for trying out.

The case makes a good impressuon but it does NOT FIT WITH THE FIXED HANDLE. (No chance!) Also there is no protection for the gimbals at all. Not agains pressure nor ratteling araund. Same problem whe trying the TX16S. This might also fit without the handle but there are two thinigies for the fingers on the backside of it the might be a problem. I don't want to remove them just for trying out.

RadioMaster I purchased the TX16S I purchased the standard special case because it was too bad to use If you buy T18 for Jumper T16/T18, it seems to be offered in this case We're going in TX16, but there's a little problem The rear grip of the TX16 hits a bump Also hits the handle (?) on the back I customized the T16 handle and removable antenna when installing the T16 carbon bezel I can't confirm the antenna, but I don't think the handle will come in as standard If you are thinking of purchasing TX16, please be careful to change the handle and work the grips for the grips or the work for the grips.(^-^)

RadioMaster TX16Sを購入しましたが 標準で付属する専用ケースが あまりにも酷く使えないため購入しました Jumper T16/T18用でT18を購入すると このケースに入れられて提供される様です TX16でも入りますが少々問題もあります TX16の背面のグリップの出っ張りが当たります 同じく背面のハンドル(？)も当たります 私はT16のカーボンベゼルを取り付ける際に T16のハンドルとリムーバブルアンテナにカスタマイズしましたので収まりましたが アンテナは確認できてませんが ハンドルは標準だと入らないと思います もしTX16で購入をお考えの方がいらっしゃいましたらハンドルの交換とグリップの出っ張りの加工もしくは出っ張り用の加工が必要になりますのでお気を付けてください(^-^)

RadioMaster I purchased the TX16S I purchased the standard special case because it was too bad to use If you buy T18 for Jumper T16/T18, it seems to be offered in this case We're going in TX16, but there's a little problem The rear grip of the TX16 hits a bump Also hits the handle (?) on the back I customized the T16 handle and removable antenna when installing the T16 carbon bezel I can't confirm the antenna, but I don't think the handle will come in as standard If you are thinking of purchasing TX16, please be careful to change the handle and work the grips for the grips or the work for the grips.(^-^)