Fits insta360go2 perfectly. A bit hard to get on the quad, though. I recommend using a plastic tool to stretch the 3D print to get the camera on there.

Fits insta360go2 perfectly. A bit hard to get on the quad, though. I recommend using a plastic tool to stretch the 3D print to get the camera on there.

Fits insta360go2 perfectly. A bit hard to get on the quad, though. I recommend using a plastic tool to stretch the 3D print to get the camera on there.

It works well holding the Insta360 Go but the weight makes it tricky to come out of dives & battery sag becomes an issue (although I am flying PH2.0 520 GNB batteries).

It works well holding the Insta360 Go but the weight makes it tricky to come out of dives & battery sag becomes an issue (although I am flying PH2.0 520 GNB batteries).

It works well holding the Insta360 Go but the weight makes it tricky to come out of dives & battery sag becomes an issue (although I am flying PH2.0 520 GNB batteries).

firebabyにフィットし非常に良いです。ただ、重たくなるぶん飛行時間は大幅に減りました。

firebabyにフィットし非常に良いです。ただ、重たくなるぶん飛行時間は大幅に減りました。

firebabyにフィットし非常に良いです。ただ、重たくなるぶん飛行時間は大幅に減りました。

Arrived on the 9th day after ordering. Thank you for handling it quickly. I will slowly check the contents from now on.

Arrived on the 9th day after ordering. Thank you for handling it quickly. I will slowly check the contents from now on.

Arrived on the 9th day after ordering. Thank you for handling it quickly. I will slowly check the contents from now on.

would not have been needed. the camera is too heavy for the small quad

hätte man nicht gebraucht. die Kamera ist zu schwer für den kleinen Quad

would not have been needed. the camera is too heavy for the small quad

all good

all good

all good

good

good

good

Good

Good

Good

nice strap

nice strap

nice strap

so i dont think this was correct. the camera doesent really fit. it is very loose and the connector for cam control is getting squeezed pretty hard... perhaps i got a missprint?

so i dont think this was correct. the camera doesent really fit. it is very loose and the connector for cam control is getting squeezed pretty hard... perhaps i got a missprint?

so i dont think this was correct. the camera doesent really fit. it is very loose and the connector for cam control is getting squeezed pretty hard... perhaps i got a missprint?