Banggood

cet ESC basée sur le VESC 4.12 et super bien je pense que c'est le moins cher que l'on peut trouver prémonté et avec les condensateurs d'intégrer super rapport qualité-prix encore merci banggood il a aussi presque le dernier firmware d'installer dont compatible avec VESC tool

Running on a longboard. 6374 motor. Milwaukee batteries. 12Ah 18v 5s goes 26kmh and gets 25km range! reaches top speed in two to three seconds. order lots of banana bullet connectors. a 10 pack should do. the esc comes with bare wires. heat shrink and your golden!

I wanted this for a long time. I enjoy using it and I'm learning a lot from it. If you want to really learn how a serious ESC works and you want control over what happens and why when using a DC brushless engine, then buy this or another VESC clone. It's great and really I can't wish for a better learning experience. The fact that it's also practical just adds to the point.

Just wired this up with a Flipsky 6374. So far so good. But, the hall sensor harness that comes with the ESC was wired backwards. I realized that after plugging in the hall sensor the ESC would not turn on. I ended up swapping positions for the red/black wires and the white/green wires (one was for temperature and other was one of the hall sensor wires) and everything booted up fine and was able to program in VESC tool.

amazing product easy to use and very beefy compared to its 4.20 ver which i also orders and never worked i would buy this 100 times out of 100 after owning both just a much better product

Fantastico esc utilizzato per skateboard elettrico. Molto programmabile e customizzabile. Consiglio vivamente per il prezzo conveniente e la potenza altissima.

Works well as expected. Running up to 1200w at 36 volts with little heat. Worth getting the metal case to protect it further. Protect from moister. I am using it in a boating application and my usb is unreliable with what a presume is a bit of corrosion on the terminals.

great esc and fast shipping. I'm using this vesc in a project where i will be load testing a alternator i converted into a brushless motor. sup to keep up to date of new videos https://youtu.be/neVlOvVjhD4

ottimo prodotto

Mine are working fine after a bit of teething. I limited the power to 29amp and max erpm to 60000, and min erpm to -60000. This is for a dual 6374 motor at 149k. Check out electric-skateboard.builders for more help. Lack of connectors is not a minus -- everyone's set-up will be different. Wire are attached to caps (they are cut into the wire). This is possibly a weak point but has held up so far. I have also attached heatsinks to the fets which help dissipate heat.