Customer Reviews

4.94 out of 5
See all 94 reviews
Write a Review
  • All Reviews (94)
  • Image (18)
  • Video (0)
  • All Star
    • All Star(94)
    • 5 Star(88)
    • 4 Star(6)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (Australia)
|
Show Original

A part of the review has been auto-translated.

  • 01/04/2021

    The Razor is a great airframe and an excellent flier. It's a clever design, the parts are sturdy, assembly is easy, and the plane comes easily apart to fit in a compact box. It's a great plane for a backpack or to pack in a suitcase. BUT... The stock prop and spinner are trash; they are difficult to balance and introduce a lot of vibration. Toss them and buy a quality 40mm aluminum spinner and blades for 3.17mm motor shaft. This is a big plane for the recommended 2S 18650 lithium ion pack. Get high-drain lithium ion cells rated for at least 20 amps continuous. 10-amp cells can't keep up; the plane lacks power and flight times are short. If you want long flight times, consider building a 3S 18650 pack (two cells forward, one to the rear) or a 2S 21700 pack with Samsung 40T 4000mah cells end-to-end extending under the wing. With a 2S Samsung 40T pack, I get 30-40 minute flights. Too bad the battery compartment isn't big enough for a 2200 mah lipo, which is what this plane really needs. The FPV battery hatch cover accommodates a simple camera like the Runcam Racer3, but there isn't enough clearance between the hatch and the battery to easily fit a camera/DVR setup like the Runcam Split 3 Micro. I wound up building a camera pylon to mount the Split 3 Micro on the hatch over the flight controller, with the DVR board mounted on the bottom of the hatch cover. For short LOS flights, this plane is great right out of the box. With a few easy mods, it's a great plane for longer FPV flights. Either way, replace the stock prop. It's trash.

    Comments (2)
    Show Original
  • 20/11/2020

    I pre-ordered a Razor FPV-version on September 22nd, 2020 and the delivery to Germany took a little longer than expected. But today I got a nice parcel with no damage. The Razor looks pretty good, is very similar to a ZOHD Drift and a bit bigger. It is very easy to assemble in less than 15 minutes. Then you just have to install a receiver and a battery and configure the FC a bit, since it is apparently a downsized ZOHD KoPilot. I am already familiar with the Drift and will maiden my Razor as soon as the whether is okay again and I do not expect any problems.

    Comments (2)
    Show Original
  • 19/11/2020

    Please be careful if you are aiming for this. I thought that the size and price were reasonable, but I ordered the KIT, but the connector of the servo is small, and the board of conversion is attached to the base of the wing, and I return it to the normal size and send it to the receiver. The servo can be easily mounted with 9g by making a little incision in the mounting part of the blade. The problem is the connector. Also, the length of the wire is subtly short. The 2208 motor is 2600KVA and the 2S 1100-1500mA battery is recommended. We are planning to do something with 2212 1400KVA 3S 1000mA, but we are planning to install the 2212 2206, which has a different pitch for the mounting hole of the motor, but it seems to be quite difficult because it is a semi-finished machine. Also, I'm thinking of adding a ladder, but I'll do something because it seems that I can get enough space to put the servo on. I thought I'd put it together and fly it for the next holiday, but that's impossible.

    Comments (2)
    Show Original
  • FPVVIP4
    DE
    02/07/2021

    The model has arrived well and also looks good am just at building and rebuilding together. A nut has been missing where fuselage connects with tailpipe. Who does not like screw should not take the model variant kit. Where you have to get motor speed control servos receiver and install it. So more I can say unfortunately nothing about it.

    Comments
    Show Original
  • 08/05/2021

    This is the kit Razor, great fun to fly. I have two and both needed to have to be reset for each flight, found that both had a crack between fuselage and boom, easy to fix with a bit of glue and both fly smoothly and almost effortlessly, comes highly recommended

    Comments
    Show Original
  • 01/03/2021

    Great little glider, its very well made and its easy to fly. The FC in it is very good in that it's radius is about 70 meters 1/2 that of the ZOHD Kopilot yet it circles at about three times the altitude ( about 250 feet) so its much safer in RTL mode. If you accidently nose in in a hard crash the head on the single nylon M3 nut holding each wing in place will simply snap off and you can expect very little damage UNLESS you were going WAY too fast into the crash. Do NOT expect to get the CG set properly with the recommended 2S 18650 3500 MAH battery but it's fine when the battery is pressed back towards the tail if you use a lighter pair of 18560s cells in the pack. Its very easy to fly in Stabilize mode. The VC-400 Cam's rez is fine for flying it ( tho not that great with the prop spinning) and it does display the remaining Battery Voltage, and the duration since it' was powered ON

    Comments
    Show Original
  • 20/11/2020

    Turned up well packed with no damage. went together easily, no glue just a few hand screws. Very happy with the quality of the parts and the way they fitted together. I got the FPV Version and it came with the flight controller, GPS and servo's installed. The camera is a rebadged ZOHD VC400-CP, the flight controller is very basic you can't change the gains but it has have voltage monitoring and will return to home when the voltage drops to certain level. Comes with the choice of 3 different colour decal sheets Except for the motor position it's basically a larger ZOHD Drift? Just waiting for the weather to improve for a test flight.

    Comments (3)
    Show Original
  • 11/11/2020

    nice product and designe, easy to build, but not test yet, hope it fly well

    Comments (1)
    Show Original
  • 25/06/2021

    The gyro and the GPS sensor have been removed and replaced by a conventional receiving system. The propeller was also useless and had to be replaced. When applying the decor, I had to use my craftsmanship. It is difficult to detach from the backing layer. Despite everything, it has become a beautiful model with excellent flight characteristics. https://youtu.be/-aUfME6aFsI - use

    Comments
    Show Original
  • 28/02/2021

    Love the Eachine products. This is no exception, went together well and flies like a dream. I did swap out the prop for an alloy 8 inch foldable one though, no problems. Great value for the money... Highly recommend.

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • AU$102.22
    • AU$73.59
    • AU$167.92
    • AU$164.92
    • AU$51.43
    • AU$61.32
    • AU$74.96
    • AU$81.77
    • AU$167.92
    • AU$32.97