All Messages

Q: Is it optical zoom? What is the range?

Asked by Graham on 2019-07-06 11:36:23

VikiChan There is some zoom possible, but never tried today measure the actual distance

2021-09-29 02:35:05 Helpful (0)
Answers (2)

Q: is it a colour screen?

Asked by Graham on 2021-06-30 08:25:33

The seller No,this is Touch EInk Display.

2021-07-01 01:37:05 Helpful (0)
Answers (1)

Q: Does it work with Home Assistant?

Asked by Graham on 2021-03-09 06:28:12

m1ch4l I use Alexa without problems ....

2021-03-20 11:40:38 Helpful (0)
Answers (2)

Q: Can I use it through an MQTT broker?

Asked by Graham on 2021-03-09 06:27:44

Scuttle_butt it is not zigbee item, so it can use MQTT

2021-03-11 12:58:29 Helpful (0)
Answers (1)

Graham 5002 also worked for me with traccar.

thebestvip84 16/08/2017
To anyone reading this post with the same issue as me. I tried for 2 days with, wasted my time & money on SMS credits. I also tried When I was about to give up I tired the following: Send: adminip999999 5002 to the 'TK-102' (TK-103) (I tried ports 5001 & 5006 without luck but 5002 works!) Go to Register (free) Log in & add a device with number: Secondly, unlike other devices this clone device doesn't use its imei as its identifier, it uses the last 11 digits of its imei with an additional 0 at the beginning. EG: your imei:352887072630899 use identifier: 087072630899 Has anyone sucesfully connected their TK-102 to I have a TK-102 from eBay Looking in forums it says to treat as a TK-103 so I set port 20157 (for Tk-102) & that didn't show, when I swapped to 20222 (TK-103) on & it shows my id of 087072814571. I changed to adminipXXXXXX 20222 & entered this in to with type Xexun TK-103, sim in tracker mobile number +44XXXXXXXXXX & password for device but will not show. All APN is configured & device check shows: GSM: 099% GPS: OK GPRS: ON BATTERY: 094%. I have tried several other ports suggested in the forums but nothing is working. The GPS tracker sends SMS ok. Commands sent: begin123456 password123456 XXXXXX (changed password) adminXXXXXX +4477XXXXXXXX (set authorised number to my mobile) gprsXXXXXX (enabled GPRS) APNXXXXXX giffgaff password (set APN with info from their website) t030s***nXXXXXX (Activated tracking) adminipXXXXXX 20222 (shows id on checkXXXXXX (returned GSM: 099% GPS: OK GPRS: ON BATTERY: 094%) adminipXXXXXX 2022 (change to point to All commands return ok! - no errors. Device remains offline on both versions of & app.
Comments (2)

Q: how would you connect this to a pc to program it? Thanks

Asked by BG135516141 on 2021-01-18 08:31:30

Graham Use a USB to serial converter set to 3.3V. Wire it to the RXD and TXD pads on the board. Ground GPIO0 when powering up to put it into flashing mode. I'm going to get one to try.

2021-01-18 11:28:52 Helpful (0)
Answers (2)