All Messages

Johan To bad it will not function with Linear Advanced with these drivers, needs the newer tmc2209 or better.

2022-02-03 04:17:42 Helpful (0)
Submit
Answers (5)

Johan I believe that the Ender-3 V2 already have this board, the biggest problem with this is that it's not able to handle Linear Advanced.

2022-02-03 04:15:30 Helpful (0)
Submit
Answers (6)

Q: The CR-10 has a 310x310mm heatbed, not 300x300mm.

Asked by Johan on 2020-10-03 05:05:00

Tritavus https://www.banggood.com/Creality-3D-310+320+0_5mm-PEI-Printing-Plate-Kit-with-PEI-Platform-and-Soft-Magnetic-Sticker-for-CR-10-Series-3D-Printer-Part-p-1705499.html?rmmds=detail-left-hotproducts__5&cur_warehouse=CN I think you can consider this one

2020-11-04 04:10:14 Helpful (0)
Submit
Answers (1)

Q: Is it possible to use this with a Prusia Clone with 2 z axes?

Asked by micim987 on 2019-06-25 07:38:32

Johan Just wire them in series and you are good. I have like this on my CR10 and on my TronXY X5S, both have closed loop belt connecting the two Z-screws and both work perfectly, I use BLTouch to get the Z hight in the middle and the leveling never change.

2020-10-07 03:46:43 Helpful (1)
Submit
Answers (4)

Johan Doesn't work good, after a lot of work to find out why my printer did diagonal artefacts in my prints, I finally found out that this stepper produces them, have now changed to an exactly the same motor and now it works fine, strange that two identical steppers can be so different.

Johan 02/10/2019
2
Comments (1)

Johan Asnyou can see, it's an Ender-3 Pro inside so I figure it will fit okay.

2020-01-06 08:27:34 Helpful (3)
Submit
Answers (2)