All Messages

downloader9 2020-07-29 19:04:05
4
Recommendations
Comments (0)

Top reviewers you may like:

downloader9 2020-08-18 22:57:06
0
Recommendations
Comments (0)

Top reviewers you may like:

Q: what's the correct current sensor scale in betaflidht for this one?

Asked by downloader9 on 2020-06-16 10:30:19

guru_meditation In the description it clearly says 210. Did 210 not work for for you or why do you ask?

2020-07-01 06:53:47 Helpful (0)
Submit
Answers (1)
downloader9 2019-07-30 08:14:40
2
Recommendations
Comments (0)

Top reviewers you may like:

downloader9 2020-05-19 07:28:38
0
Recommendations
Comments (0)

Top reviewers you may like:

downloader9 2020-05-19 07:30:23
0
Recommendations
Comments (0)

Top reviewers you may like:

downloader9 2020-05-19 07:28:48
0
Recommendations
Comments (0)

Top reviewers you may like:

downloader9 2020-05-19 07:27:34
0
Recommendations
Comments (0)

Top reviewers you may like:

downloader9 2020-05-19 07:26:56
0
Recommendations
Comments (0)

Top reviewers you may like:

Q: what are the things that come inside the package ?

Asked by Arjun Anbarasan on 2019-03-04 12:27:37

downloader9 The 4in1 ESC, one 8pin cable to connect the 4in1 to the Flight controller and one low esr capacitator.

2020-02-07 03:28:12 Helpful (0)
Submit
Answers (2)

Q: What's the scale for the current sensor in betaflight?

Asked by guru_meditation on 2019-01-30 02:23:29

downloader9 85 is the correct value.

2020-02-07 03:26:26 Helpful (0)
Submit
Answers (4)

thegamingguineapig the ridges would theoretically turbulate the air flowing over the blade as it rotates and will thus delay the boundary layer separation. that means that the blade will stall later and that a higher pitched prop can be used without efficiency losses of (partial) blade stall. however I have no idea of these ridges will actually achieve this effect, but theoretically it would make for a very efficient high pitched prop.

2019-11-08 01:59:27 Helpful (0)
Submit
Answers (6)

Q: mounting hole pattern. obviously 3 hole, but what diameter

Asked by pothman on 2019-05-22 01:29:45

downloader9 6.6mmfor the all diameter in all holes, this is the same as the EX1102 from Happymodel...

2019-05-24 12:09:30 Helpful (0)
Submit
Answers (1)

Q: LHCP version? Thanks

Asked by frimen on 2018-01-23 12:33:39

downloader9 yes lhcp please

2018-02-07 04:53:13 Helpful (1)
Submit
Answers (4)
downloader9 2019-05-10 10:19:55
1
Recommendations
Comments (0)

Top reviewers you may like:

Q: All that current (320A peak) thrue the small shunt ?

Asked by desjaak on 2019-01-17 06:44:23

downloader9 lol, the current sensor only goes up to 100A, it's enough for 6s, but for 4s i would like to see 2.

2019-05-01 06:32:51 Helpful (0)
Submit
Answers (2)