All Messages

Q: What should I buy besides this kit to install it on the ender3v2?

Asked by BG101643191 on 2020-11-26 05:56:37

Soultrap102 Agree with answer from Halinalle

2022-02-27 02:42:38 Helpful (0)
Submit
Answers (2)

Q: Can it use with BIQU B1?

Asked by sutees on 2020-08-29 09:55:22

Soultrap102 If the Biqu b1 supports BLtouch this will work. Just check if you need longer cables.

2022-02-19 03:17:58 Helpful (0)
Submit
Answers (3)

Q: questa scheda va bene per anet a8 plus ?

Asked by AngeloDonofrio on 2021-06-07 04:47:49

Soultrap102 It was made as a drop in replacement for the ender 3. But many people have used them for custom printers.

2022-02-18 01:47:32 Helpful (0)
Submit
Answers (2)

Q: This will work for an Ender 3 V2?

Asked by BG571855590 on 2020-12-16 03:34:01

Soultrap102 The ender v2 has a probe port. Just make sure you check what order you connect the pins.

2022-02-18 01:46:19 Helpful (0)
Submit
Answers (3)

Q: va bene su scheda madre skr 1.4 turbo?

Asked by guido_1982 on 2020-01-12 02:58:39

Soultrap102 Not sure, but it works on my skr mini v2 for ender 3

2022-02-09 06:28:27 Helpful (0)
Submit
Answers (2)

Q: Will this work on an Anet A8?

Asked by colly on 2018-11-27 12:09:37

Soultrap102 Based on size of bed. Ender is a little bigger than some 3d printers

2022-02-09 06:27:32 Helpful (0)
Submit
Answers (3)

Q: Is it possible to provide a 2-meter extension?

Asked by BG231016434 on 2020-09-08 03:41:09

Soultrap102 I also found the extension a little short

2022-02-09 06:25:59 Helpful (0)
Submit
Answers (3)

Q: Does it work with Ender 3 ?

Asked by panmourtas on 2020-04-15 01:00:58

Soultrap102 Yes worked for me. It takes over the Z stop. You may need to install custom firmware to add mesh bed leveling.

2022-01-18 05:27:39 Helpful (0)
Submit
Answers (3)