All Messages

Matt051 2020-10-03 16:26:28
0
Recommendations
Comments (0)

Top reviewers you may like:

Matt051 2020-10-03 16:06:35
0
Recommendations
Comments (0)

Top reviewers you may like:

Eduardo Vendrell They are shiipping a newer version, 1.2. Theorically you have to solver to RX2 but the board is labeled WRONG!!! so where it says TX2 is actually RX2 and viceversa!!!!! I was going mad as I have 2 1.2 boards that I had no way to connect with flysky rx and 1 1.1v board which is labelled correctly!!! hope it helps!!!

2020-09-12 03:57:54 Helpful (0)
Submit
Answers (1)

Matt051 I tried two different types of Flysky receivers on the board and still had no luck. Done exactly the same as you tried ibus and sbus. Did you have a go at soldering the signal to the R2 solder pad? I didn't have much luck coming from it but you might. l also tried bridging the two DSM solder pads, to see if that would work. Still no luck it was a waste of money.

Jayjay63737 2020-01-16 15:29:26
5
Comments (5)

Q: Which stack mounting 16x16 or 20x20?

Asked by Michel on 2019-09-28 01:55:19

Matt051 16x16 or go with whoop size board

2019-10-24 03:10:07 Helpful (0)
Submit
Answers (1)

Matt051 haha its a great little flyer, you wont be disappointed. Great for them small areas like play grounds. Good luck with the build, when it completed put a picture up with you review.

Matt051 2019-08-29 13:54:55
1
Comments (2)

Matt051 Yes you can put a flysky receiver on it, you solder to a different pad on board go to geprc website and it shows you the diagram where to solder on to for the V1.1 board. The receviver l used was the Fli14+ it has the out put for RSSI built in, you just have to enable RSSI on channel ten on your reciever tab in betaflight.

2019-07-21 02:10:18 Helpful (0)
Submit
Answers (1)
Matt051 2019-03-23 16:00:34
0
Recommendations
Comments (0)

Top reviewers you may like:

Matt051 2019-08-10 11:18:24
0
Recommendations
Comments (0)

Top reviewers you may like:

Matt051 2019-06-04 15:28:20
0
Recommendations
Comments (0)

Top reviewers you may like:

Matt051 2019-03-23 16:28:34
0
Recommendations
Comments (0)

Top reviewers you may like:

Matt051 2019-03-23 16:05:03
0
Recommendations
Comments (0)

Top reviewers you may like:

Matt051 2019-03-23 15:44:55
0
Recommendations
Comments (0)

Top reviewers you may like:

Matt051 2019-03-23 15:42:29
1
Recommendations
Comments (0)

Top reviewers you may like:

Matt051 2019-03-23 15:38:55
0
Recommendations
Comments (0)

Top reviewers you may like: