theuglycamel
My Contents
All Messages
Reviews
Comments
Answers
Questions

All Messages

25g Digital Servoless Metal Electronic Retractable Landing Gear for Airplane KTK
US$13.50 US$17.99

Q: Hello. Anybody Knows if this one fits in the Durafly Bf-*****mm wingspan?

Asked by rivarella on 2020-12-30 07:50:50

theuglycamel Should work just fine, used mine on a 1m ft cruiser.

2020-12-30 08:05:21 Helpful (0)
Submit
Answers (1)
30.5x30.5mm Racerstar REV35 35A BLheli_S 3-6S 4In1 Brushless ESC Built-in Current Sensor Support DShot600 for RC Drone FPV Racing
US$35.99 US$37.99

Q: I’m building a drone and don’t wana buy a 73 dollar ESC and flight controller combo is this a good alternative?

Asked by BG465754452 on 2020-10-21 06:59:22

theuglycamel Absolutely, running sunnysky 2307 2700 KV on a 630g rig. No issues with bidirectional dshot either.

2020-10-21 01:24:52 Helpful (0)
Submit
Answers (2)
theuglycamel 11/12/2019
Excellent packaging and shipping time. This is my first PNP wing and I'm VERY impressed. Everything fit perfectly and the EPO is very very strong. There's tons of room for flight controllers/batteries/VTX. I'm setting mine up on an APM FC and hoping to make this my first waypoint autopilot rig. A+++
Sonicmodell AR Wing 900mm Wingspan EPP FPV Flywing RC Airplane PNP
US$169.39 US$184.79
1
Recommendations
Comments (0)
MAMBASYS F405 MK2 Betaflight Flight Controller F40 40A 3-6S DSHOT600 FPV Racing Brushless ESC 30.5x30.5mm
US$95.99 US$119.00

Q: Can I put a Beitian BN-880Q GPS module on this board and where do I need to solder it ? (TX ? RX ?) thx

Asked by parveauadrien on 2020-01-17 08:49:26

theuglycamel Yes, that model will work. opposite of the USB, there are connections for scl sda, these connect to the compass, next to scl is the ground, 5 volt, tx and rx for the GPS. Remember tx goes to rx and rx goes to tx. You'll want to set the uart for GPS once you're wired in.

2020-01-17 09:03:19 Helpful (0)
Submit
Answers (4)
Hawkeye Firefly Micro Cam 160 Degree HD 1080P FPV Mini Action Sport Camera DVR Built-in Mic for RC Drone Car
US$25.83 US$30.00

Q: Can I take live feed via USB to a computer onboard? I need it for image processing purposes. Or over WIfi?

Asked by aatmadeepaarya on 2019-01-15 04:21:09

theuglycamel Yes,There is quite a bit of latency over USB but it will work. No WIFI options though.

2020-01-15 12:37:45 Helpful (0)
Submit
Answers (1)
theuglycamel 13/01/2020
Can't say anything bad about the oldest pdb on the market. works great and easy to solder.
Matek Systems PDB-XT60 W/ BEC 5V & 12V 2oz Copper for RC Drone FPV Racing Multi Rotor
US$10.99 US$11.99
0
Recommendations
Comments (0)
theuglycamel 13/01/2020
This is currently my favorite airplane by leaps and bounds. After I trashed the PNP version, I purchased a kit version to replace the broken bits. On that point, this plane is the toughest wing I've ever flown. I love blasting through trees and nose diving into the ground at Mach OMG. The only thing that could destroy this thing was a full throttle run through a barbed wire fence. Even then it was fixable, just a bit lopsided. Currently I'm running the stock ESC (FlyColor 30a w 3aBEC) on a Sunny Sky 2216 1400KV on 3s. I run dual Ovonic 2200 MAH and get close to 25 min of flight time if I stay out of the throttle. The ESC is a little light for this motor on 4s but I have yet to see the need. I also run a HK AMP 2.7.2 Flight stack with PDB, OSD/Telemetry board, and An AKK 1000mw VTX. Even with this old 8 bit FC I can run auto takeoff, flybywire, return to home, mission planner, and acro/stabilize modes.
Sonicmodell AR Wing 900mm Wingspan EPP FPV Flywing RC Airplane KIT
US$99.99 US$155.99
0
Recommendations
Comments (0)
theuglycamel 13/01/2020
These are SUPER small cameras. I hated the fixed CMOS camera on my Fat Shark shark quad so I cut the factory camera out and mounted this one in its place. Not only is this camera WAY clearer than the factory, I think I saved a gram or two. I didn't mount this on an adjustable mount, but adding 30 degrees of up-tilt made this quad a blast to rip. I'm using my second camera on a servo gimble on the top of my AR Wing. I'm running a three way switch so I can change between my FPV camera, my HD camera, and this one. It's so light the wing acts like it's not even there. My tiny 3.7g servo is heavier than this thing! Don't be fooled by TVL lines. I've got cameras rated for 1500TVL that look worse than these do. It does have some lighting issues but that's to be expected on a bare bone CMOS camera. This is a great camera for a toothpick build or a sub 250g fixed wing FPV rig.
1/4 CMOS Mini FPV Camera 600TVL 1.8mm FOV 170 Degree Wide Angle PAL/NTSC 5V-12V
US$14.29 US$15.59
0
Recommendations
Comments (0)
theuglycamel 13/01/2020
Exactly what you need for running OSD and 915/433mhz telemetry on an older APM. I'm using an APM Mega 2.7.2 minimOSD and a FPVDrone 3dr 915mhz telemetry kit, and this works perfectly. Well made and well packaged. Plug and play without any configuration necessary.
APM 2.5 APM 2.6 Digital / OSD Telemetry Y Type Cable
US$7.99 US$8.99
0
Recommendations
Comments (0)
theuglycamel 13/01/2020
Not a very popular item as APM 2.8 and below aren't supported by mission planner anymore. However, some of us like the challenge of building a 2014 aircraft and making it do all of the tricks (and more) than newer F4/F7 boards. The cables are well made and extra long for any type of setup. If you're purchasing these because you don't have any of the factory cables, buy two sets as you'll need both ends for telemetry and PDB connections. Also, be extra careful un-pinning these connections, the retainer tabs do snap off easily.
Wire Cable Set For MiniAPM Mini APM V3.1 Flight Controller
US$7.88 US$14.99
0
Recommendations
Comments (0)
theuglycamel 13/01/2020
I purchased the 2.5mm to go on my Fat Shark 900tvl Cmos. Looks great, no fisheye and focused very clear. Major improvement over my 2.8 I was running. Using this on a Sonicmodel AR Wing 900mm.
2.5mm/2.8mm 600TVL 1/3" Super Had II CCD Camera IR Sensitive Replacement Camera Lens for HS1177
US$3.95 US$9.59
0
Recommendations
Comments (0)
theuglycamel 13/01/2020
Beautiful well balanced props. I've smashed them into walls all weekend without any breaking. I'm using them on a FatShark Shark quad with 8250 brushed motors. Lots of low end torque, quiet and very smooth. Definitely will be buying more!
4 Pairs GEMFAN 65mmS 65mm 2-blade 1mm/1.5mm Hole Propeller for Toothpick RC Drone FPV Racing
US$3.29 US$8.99
0
Recommendations
Comments (0)
theuglycamel 13/01/2020
Do exactly as they were designed to do. I use one on my patch antenna (cap lhcp to get full rhcp). I use the other on the bench when powering up my VTXs without an antenna. Shipped fast and work great!
2pcs SMA Male RF Coaxial Termination Matched Dummy Load 50 Ohm Terminator For FPV RC Drone
US$8.79 US$9.59
0
Recommendations
Comments (0)
theuglycamel 13/01/2020
Excellent lightweight servos. Gearing is smooth and resolution is flawless. Comes with every type of servo horn imaginable. I'm using two of these for elevons for my Soncimodel AR Wing 900 and they blow the stock servos away. Improved responsiveness and rigidity in top speeds flights. These are my new favorite 9g servos!
JX PDI-1109MG 9g Metal Gear Core Motor Micro Digital Servo for 450 RC Helicopter
US$7.71 US$13.99
0
Recommendations
Comments (0)
theuglycamel 08/01/2020
Very well made 3D print. Fits perfectly, super light and flexible. No jello whatsoever. Will definitely be buying more.
1PC 25*40*43.5mm 25 Degree TPU Protective Case for Hawkeye Firefly Micro Sport Camera Red/Blue/Orange
US$3.04 US$6.13
0
Recommendations
Comments (0)
Sonicmodell AR Wing 900mm Wingspan EPP FPV Flywing RC Airplane PNP
US$169.39 US$184.79

Q: what’s the best controller for this plane?

Asked by AlexanderMcMyn on 2019-06-17 04:14:28

theuglycamel It'sreally a matter of opinion. I'm partial to Arduplane so went with an older apm setup. The most popular would be the Matek f405 or f411. Both are excellent flight controllers and should have plenty of room to mount.

2020-01-07 12:22:24 Helpful (0)
Submit
Answers (1)
1/4 CMOS Mini FPV Camera 600TVL 1.8mm FOV 170 Degree Wide Angle PAL/NTSC 5V-12V
US$14.29 US$15.59

Q: I got the cameras without adaptive cable, can I connect it directly to 12v without burning anything?

Asked by FRodrigues on 2019-05-30 09:57:10

theuglycamel Yes,any dc 5-12v source will work.

2020-01-07 12:20:02 Helpful (0)
Submit
Answers (1)
theuglycamel 07/01/2020
By far the best flight stack for the money. The layout is simple, and easy to solder. The osd is effortless and the provided stack is very robust. You simply cannot find a ready to mount 6s rig for this price. My only complaint would be blheli-s instead of blheli32, but Betaflight now supports rpm filters on blheli-s so no big deal there. I've been running Betaflight 4.1 on a 680g aluminum 5" quad. Even with the weight I rarely get close to over-amping the esc. As long as they keep selling these, I'll keep buying them.
MAMBASYS F405 MK2 Betaflight Flight Controller F40 40A 3-6S DSHOT600 FPV Racing Brushless ESC 30.5x30.5mm
US$95.99 US$119.00
0
Recommendations
Comments (0)
theuglycamel 06/01/2020
This is by far my favorite HD cam for fpv. Although its not 4k, the image quality is great and the camera is SUPER light. I have this setup to swap between my AR Wing and my Kraven 5" freestyle "cruiser". Its so light you can't even tell it's on the quad. I also have it wired in to a 3s on my wing so I can get longer record times. This also allows me to transmit the HD feed separately from my FPV camera for spectators to use. All you need to do is modify the charging cable that comes with the camera and add a cheap vtx to the video out. Best of all, if you bust it, it's only 25 bucks! FYI be sure the camera is fully charged if you want to wire it into your main battery pack. If not, the camera will enter charge mode when connected and draw quite a few amps.
Hawkeye Firefly Micro Cam 160 Degree HD 1080P FPV Mini Action Sport Camera DVR Built-in Mic for RC Drone Car
US$25.83 US$30.00
0
Recommendations
Comments (0)

You are the expert,can you help?

We sincerely invite you to subscribe to the Invite Answer email!

If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.

Help others and be happier!

  • Subscribe

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.Specific people will also have their own exclusive badge.
CEO Badge

The CEO Badge is owned only by the boss of Banggood.

Badges you can earn are coming soon
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe