Noel
Noel This card is designed to switch off the laser when a high signal is on the pwm connection and low for high power which is the reverse of the EleksMaker laser. There is a control board that has both types of pwm connections -pwm low_off, high_on (the red connection) and also pwm low_on. high_off (the white connection) both able of course to control power between off and full on as a pwm action. The board has "CAMTOOL CNC V3.3" on it. An additional thing to note is the sequence of +12 volt, pwm and ground on the boards is different than the laser with pwm and ground reversed. You can carefully use a pin to release the individual wire ends and switch the sequence in the cable end to place in the controller board. The two boards look very similar except for the additional connection and both accept the optional offline controller. When you use your computer with say LaserGRBL software you must disconnect the offline controller as the two do not work together but both have their uses.
2019-05-29 05:28:53 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
