starfighter81
starfighter81 It comes preflashed with marlin but you need to adjust and flash the firmware to match your printer. Steps per mm, thermistors, endstops, temperatures etc. are all different for every printer! You could adjust most parameters using the display and g-code commands, but in many cases you will need to customize (and compile) the firmware to suit your hardware. Luckily the are ready made firmwares for lots of printers out there. And if not, just ask for help in the great 3d-printing-community on social media and forums.
2023-11-20 12:50:47 Helpful (0)
starfighter81 There is no reliable way to tell even if they were marked. You need to connect the motor and check. If it runs the wrong direction you simply flip two wires around.
2023-11-15 08:30:08 Helpful (0)
starfighter81 Itis coated with clear protective silicone.
2022-04-28 11:50:55 Helpful (0)
Q: Have you stock? What version of TMC5160 SPI, or normal mode?
Asked by joehiluh on 2022-03-25 03:57:05
starfighter81 The board can be configured to use TMC drivers in normal step, SPI or UART mode simply by setting the jumpers.
2022-04-11 03:20:44 Helpful (0)
Q: Is the body red? Some pictures show an ugly white-body version, and I want only the nice red one...
Asked by ThinkingOnWuhanLab on 2021-06-12 08:20:48
starfighter81 We ordered 3: 2 are white and 1 red. So it is kind of random. I think the white version received some minor updates though, but not 100% sure.
2021-07-23 12:45:10 Helpful (0)
Q: Can this be programmed for inverted signals? thx
Asked by starfighter81 on 2020-07-10 05:26:16
JunhanYu not support
2020-08-04 12:44:43 Helpful (0)Q: Can this module be configured for inverted signals? thx
Asked by starfighter81 on 2020-07-22 05:22:05
gledhillross04 yes
2020-07-25 05:00:10 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
starfighter81 This is a flight controller and has no receiver build in! You can use any receiver that outputs S.BUS, PPM (also reffered to as CPPM), ELRS and crossfire.
2023-11-20 01:02:25 Helpful (1)