All Messages

Q: Hello, which glue is recommended?

Asked by BG471316201 on 2020-08-05 03:56:30

nikkor Google for UHU Por - that's the special glue that works well and should be available in your nearest home DIY store.

2020-08-05 06:00:58 Helpful (0)
Submit
Answers (4)

Q: Is it compatible with a sbus or would I need to use it as an Ibus?

Asked by BG184781557 on 2020-05-15 01:52:24

nikkor This receiver has i-BUS and S.BUS output as well as PPM. There are 4 wires on the module: - PPM signal (8 channels via 1 wire) - i-BUS and (or) S.BUS signal (18 channels via 1 wire) - VCC (this is power) -GND (this is ground) Hope it helps. Good luck with your project!

2020-05-15 04:36:05 Helpful (2)
Submit
Answers (4)

nikkor Please check the manual: http://img.banggood.com/file/products/20161020221736TOY-MTX_Instructions.pdf

2020-04-21 05:10:19 Helpful (0)
Submit
Answers (1)

Q: what power cord do you use for 4s battery with xt60 con ?

Asked by mpsyes on 2020-02-05 07:43:16

nikkor You can use any cord with Male DC 5.5X 2.5mm at the end (facing solder iron). For example: https://www.banggood.com/RJXHOBBY-XT60-Male-Bullet-Connector-to-Male-DC-5_5X-2_5mm-DC5525-Rubber-Power-Cable-for-TS100-Electric-Soldering-Iron-p-1418863.html

2020-02-06 05:24:53 Helpful (1)
Submit
Answers (1)
nikkor 2020-01-03 10:34:14
0
Recommendations
Comments (0)

Top reviewers you may like: