bertoeless
My Contents
All Messages
Reviews
Comments
Answers
Questions

All Messages

bertoeless 03/02/2018
Although this flashlight doesn't come with batteries or charger, it wasn't 100 dollars either as was my rigid halo. It isn't quite as bright as the halo(800 lumens by the way) so the intensity isn't quite what they say, but oh well still brighter than any maglight. I would certainly buy this again, just sucks that I didn't find these before spending 100 bucks on the halo, dang.
MECO C8 2000lumens 5 Modes LED Flashlight 1x18650
US$10.18 US$14.99
1
Recommendations
Comments (0)
bertoeless 17/03/2019
haven't fried one yet but wish i had more details on programming with sticks instead of programmer
XXD HW30A 30A Brushless Motor ESC For Airplane Quadcopter
US$9.89 US$25.59
0
Recommendations
Comments (0)
bertoeless 30/03/2019
receivers with telemetry rock, though i wish the rssi worked
Flysky X6B 2.4G 6CH i-BUS PPM PWM Receiver for AFHDS i10 i6s i6 i6x i4x Transmitter
US$16.63 US$20.99
0
Recommendations
Comments (0)
bertoeless 17/03/2019
its got telemetry, failsafe, more channels than i need, and has a cute little blinky light all for less than 10 bucks, awesome.
Flysky X6B 2.4G 6CH i-BUS PPM PWM Receiver for AFHDS i10 i6s i6 i6x i4x Transmitter
US$16.63 US$20.99
0
Recommendations
Comments (0)
AuroraRC 8 Bits WS2812B RGB5050 LED Board 5V w/ Control Board 2-6S For F3 F4 FPV Racing RC Drone
US$18.88 US$17.01

Q: what are the 4 square pads on the controller board for?

Asked by luckstar on 2018-08-25 03:57:40

bertoeless my guess would be output, input, voltage, ground, which goes to what you could see by looking at the traces on the board

2019-02-26 08:25:54 Helpful (0)
Submit
Answers (2)
bertoeless 11/05/2018
tough exterior housing prevents my naughty kitties from chewing the cord up so easily, also the full data transfer is nice since most of the cords i've found in stores were only charge cords and didn't sync data, this one does so good product
3M/10FT Micro USB Charger Cable Data Sync Cord Line Lead For Android Cell Phone
US$3.21 US$2.89
0
Recommendations
Comments (0)
bertoeless 02/02/2018
The aroma is amazing. Using pure essential oil and not water soluble like in the humidifiers makes the vapor much stronger, a few minutes running and my whole house smelled like a big ball of frankincense. The colors fade from one to the next, and the dial sets how much vapor you want. It does make about as much noise as an aquarium air pump, I suspect that's how it works. My friend has an ultrasonic humidifier and it is silent, but he has to use water soluble hydrosols and can't use pure oil, so I like this one better. Plus it's actually wood and glass as well, not plastic, very stylish.
Light Wooden Aromatherapy Essential Oils Diffusers Negative Anion Aroma Fragrance Room House
US$99.20 US$110.99
1
Recommendations
Comments (0)
bertoeless 28/01/2018
the verdict is still out as far as testing, but at around 35gms a piece compared to a 2400mah i had that weighed nearly 50gms. the batteries took a charge and were very prompt to arrive. plugged into a cheapo flashlight that happened to have aaa's but was compatible and wow very bright. still works in my rigid halo(convoy c8 clone) where other batteries failed right off, so I give em a pass. gonna try em in all the lights that have that little sleeve i couldn't figure out what was for, now I know they were waiting for these batteries
10pcs 3.7V 6000mAh 18650 Unprotected Rechargeable Li-ion Battery
US$22.47 US$30.65
0
Recommendations
Comments (0)
bertoeless 23/01/2018
the base isn't exactly 4mm, it's a little bit more, it's actually two thinner pieces laminated together(common) and ends up being a little thicker. the frame is small, not a lot of room, listen to the other reviews I didn't, its a lot tougher build without an aio flight controller. other than that very strong frame(when assembled) i have brotherhobby r4 1806's(2850kv) mounted to the outside two holes making it a 225mm frame for me. A 30A four in one lumenier esc and 1500 mah 4s 90c battery and dalprop 5046c cyclones what do you think about them apples. I miss full throttle, but then again I don't need it anymore.
Anniversary Special Edition Realacc Purple215 215mm 4mm Arm Thickness Carbon Fiber RC Drone FPV Racing Frame
US$35.48 US$41.86
0
Recommendations
Comments (0)
bertoeless 23/01/2018
i use current meter on escs, but controller has none that's how they fixed the current meter problem, other than that this has altimeter osd and blackbox if it had a magnetometer it would've been perfect
Omnibus F4 Pro V3 Betaflight Flight Controller Built-in OSD Barometer SD Blackbox for RC Drone
US$26.49 US$32.99
0
Recommendations
Comments (0)
bertoeless 23/01/2018
others have called it a cmos, but i had a cmos cam and the propeller tips were quite visible, this camera however seems much better, clear picture, less visible prop tips, good low light handling capability, and it seems more fisheyed than it actually is. love it too
Eachine C800T 1/2.7 CCD 800TVL 2.5mm 150 Degree Camera with OSD DC5V-15V NTSC PAL For RC Drone
US$22.74 US$31.19
0
Recommendations
Comments (0)
bertoeless 23/01/2018
still working, had to mount outside the frame and of course broke both connectors, the wire plug I fixed with hot glue, the antenna plug(ipx,ufl) was tougher so i removed it and soldered the pigtail direct, much better, i would recommend the manufacturer to build a version like this with pigtail soldered directly to vtx.
HGLRC GTX226 5.8G 40CH 25mW 200mW 600mW Switchable FPV Transmitter VTX SMA RP-SMA Female
US$17.70 US$25.96
0
Recommendations
Comments (0)
bertoeless 23/01/2018
Great for plugging old hard drives in when you don't really want to enclose them.
USB 2.0 to SATA IDE Hard Drive Converter Cable for HD HDD Adapter W Power
US$10.89 US$11.92
0
Recommendations
Comments (0)
bertoeless 23/01/2018
with a 2a, my servos would black out occasionally, now with 3a I never have that problem. this has multiple output terminals and even two input terminals(voltage sensor connection point) love it and recommend it
3A UBEC Module Low Ripple Bluesky Mini Switch-Mode DC BEC 5V 12V 2-6S Supply for RC Drone
US$3.69
0
Recommendations
Comments (0)
bertoeless 23/01/2018
charges all batteries, prevents problems, tracks the milliamps put back into the battery, what more can you ask for. local hobby stores and your crappy venom chargers bow down before the IMAX!
Original SkyRC IMAX B6 Digital RC DC Lipo Li-polymer Battery Balance Charger
US$36.29 US$39.59
0
Recommendations
Comments (0)
bertoeless 23/01/2018
hope you like soldering, great bec not a lot of output though I have overloaded it before, it just shuts down, doesn't hurt it (at least it still works, just with less stuff hooked to it) i have it powering a cam/vtx combo that needs 5v
Diatone Mini 2A BEC V2.0 Version 3.3V 5V 12V for RC Drone FPV Racing Multi Rotor
US$3.64 US$9.99
0
Recommendations
Comments (0)
bertoeless 23/01/2018
way better than standard sg90's these are taking way more abuse and aren't that much heavier, so always get these(black post) and not the un-reinforced versions(white post) the white ones gears are stripped before you get them and the black ones I've not had a single one go bad yet(knocks on wood)
4 X SG92R Mini Micro Servo 9g 2.5kg For RC Airplane
US$15.39 US$20.39
1
Recommendations
Comments (0)
bertoeless 23/01/2018
I'm powering a scratchbuilt blubaby 600mm fixed wing airplane. It's great, runs an rs1806 brushless outrunner like a dream. It gives the little plane plenty of power and is hidden completely in foam, but doesn't heat up. I use 8 inch propellers and it will climb vertically.
DYS XM Seris XM10A BLHeli mini 10A ESC For High KV Power Electronic Speed Controller
US$6.47
0
Recommendations
Comments (0)
bertoeless 23/01/2018
I use several of these, one in a fixed wing, and two in multi rotors, and all work great. I get telemetry feedback to my fs-i6x so I know the voltage of the flight pack when flying l.o.s. I always get failsafe working, pwm and ibus both work for me but require careful setup and testing. Pwm works through the radio and ibus/sbus works through the flight controller. I would recommend this to everyone.
Flysky X6B 2.4G 6CH i-BUS PPM PWM Receiver for AFHDS i10 i6s i6 i6x i4x Transmitter
US$16.63 US$20.99
0
Recommendations
Comments (0)

bertoeless your shaft is loose, hold the bottom of the shaft against something hard and push the bell back down, then disassemble and loctite that sucker into place, if you don't disassemble the loctite will end up in the bearings, my 1104's do that in a hard crash and I just push em back up and keep flying then loctite later

Bonemyster 13/10/2017
Pros: They deliver pretty good torque and arent power hungry on 2.5inch prop. Wouldnt recommend it for 2 inch though. Con: if you pull on the motor youll see that it seperates a lot from the stator and windings this isnt supose to happen but it does still fly.My second photo show what im taking about.
Racerstar Racing Edition 1106 BR1106 3800KV 1-3S Brushless Motor For 100 120 150 RC Drone FPV Racing
US$8.94 US$17.99
3
Comments (1)

You are the expert,can you help?

We sincerely invite you to subscribe to the Invite Answer email!

If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.

Help others and be happier!

  • Subscribe

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.Specific people will also have their own exclusive badge.
CEO Badge

The CEO Badge is owned only by the boss of Banggood.

Badges you can earn are coming soon
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe