All Messages

Q: Does it work with ender 3 original hotend?

Asked by Seltix on 2022-01-21 05:40:16

monki77 It will fit and screw in, but it will stick out further than a normal Ender Mk8 nozzle.

2022-01-21 05:47:43 Helpful (1)
Answers (2)

monki77 This doesn't fit well. The small piece of PTFE tube between the hotend and extruder motor is bent because the spacers are too short. If I try to use washers, then the screws are too short. would rate this 2 stars now if possible.

monki77 31/10/2021
Comments (1)

Q: Does this have a magnetic back?

Asked by monki77 on 2020-12-16 05:58:03

Rubino No,io ho preso una base magnetica.

2021-06-05 01:59:54 Helpful (1)
Answers (4)