JorritJ
My Contents
All Messages
Reviews
Comments
Answers
Questions

All Messages

JorritJ 16/07/2019
Great fast little charger. It has a very low profile and saves stress on the usb port of your phone. Only downside is when the phone is charged at 100% the fan starts blowing. This is not noticeable in the daytime but you can hear it at night if you place it next to your head on the night stand. It's a shame because my intention was to use it in the bedroom for charging at night. I hope the next version of the charger fixes this.
Original Xiaomi 20W Wireless Charger Fast Wireless Charging Pad For Qi-enabled Smart Phones For iPhone 11 SE 2020 For Samsung Galaxy Note 20 Huawei P40 Pro Xiaomi Mi10
US$33.07 US$38.99
0
Recommendations
Comments (0)
JorritJ 30/07/2019
very nice watch! I had the mi band 3 and this is a great upgrade. Next to the obvious color display it has a higher dpi, it is slightly bigger and (the best improvement) much easier to read in daylight. It supports more exercise types and can control your music (tested with Spotify). The battery life seems better and for me the battery indicator on the display itself is a big plus. You should order a screen protector, because it scratches easily.
[BT 5.0]Original Xiaomi Mi band 4 AMOLED Color Screen Wristband 5ATM Long Standby Smart Watch International Version
US$39.99 US$99.99
1
Recommendations
Comments (0)
Upgrade Version Xiaomi Mi Smart WiFi Remote Control Multifunctional Gateway
US$39.19 US$55.99

Q: hi, is it work with Xiaomi Flower Care Monitor like a Bluetooth bridge ?

Asked by Julien-Frédérick Georges-Edouard Patron on 2018-08-27 01:45:50

JorritJ No, you have to buy a BLE-to-wifi Bridge device, like the bedside lamp or the Smart IP Camera.

2019-04-12 07:00:20 Helpful (1)
Submit
Answers (1)
JorritJ 31/01/2019
A nice little charger which comes with a manual(!!!) You have to use your own adapter (DC 9-15V) or a battery with an XT60 connector (3S). You can set the output per connection (6 in total) or set them all at the same value. It supports LiPo and LiHV and you can set the current at 100 mAh intervals. The connectors are micro, MX an mCPX so most common connectors are covered. There are some safety features: over voltage protection (battery), polarity protection (battery), over and under voltage protection (input). It also has an 5V/2.1A usb output which might come in handy in the field. For the price it is a great charger for your 1S batteries, I like it!
Ultra Power UP-S6 6x4.35W DC 1S Balance Charger for Micro MX MCPX LiPO/LiHVO Battery
US$28.59 US$31.99
0
Recommendations
Comments (0)
JorritJ 31/01/2019
Nice batteries for my Eachine Trashcan. I use these for indoor flying so I only use one battery per flight: more capacity per flight! I think they are too heavy for 2S on a Trashcan. My charger UP-S6 has a 100mAh precision so I can only charge them at 500 or 600 mAh, it does not bother me, but maybe it might be something for you to keep in mind. Overall: great battery.
5Pcs Gaoneng 3.8V 550mAh 50C/100C Lipo Battery PH2.0 Plug For Tiny RC Helicopter Drone
US$25.29 US$33.99
0
Recommendations
Comments (0)
JorritJ 03/01/2019
the drills are slightly skewed in their drillbit. This results in a lot of vibration while drilling. I don't know how long they will last, but I suspect the smaller drills will break soon. It might not be a problem if you don't use them that much and you do not use them for more precise drilling, it may get the job done A typical example that you get what you pay for.
Drillpro 13pcs 1.5-6.5mm 1/4 Inch Hex Shank High Speed Steel Twist Drill Bit Set
US$8.98 US$13.99
1
Recommendations
Comments (0)
AI Face Identification 720P IR Video Doorbell Set Motiion Detect Intercom Free Cloud Storage FJ02MLWJ
US$63.99 US$76.99

Q: is the door bell speaker 220 or 110v?

Asked by JoshBuck on 2018-12-08 03:05:14

JorritJ 100-240V, 50-60Hz. So both voltages.

2018-12-30 03:45:56 Helpful (0)
Submit
Answers (2)
JorritJ 24/02/2018
great if your solder will not stick to your soldering iron. Heat your soldering iron up (350C) stick it in the pot move it around a bit and clean on a sponge. good as new!
MECHANIC MCN-8 Soldering Iron Tip Refresher Clean Paste Oxide Solder Iron Tip Head Resurrection Repair Tools
US$4.40 US$14.24
0
Recommendations
Comments (0)

JorritJ Does it work with the v1 camera? Have you tested it yet?

tailspin 30/12/2017
Didn't come with the RF shield. Camera cable looks the same as v1, so it should fit. I broke the v1 board, so only ordered this piece. Not tested it yet.
PCB & WiFi Module for RunCam Split 2 FPV Camera
US$45.99
0
Comments (1)

You are the expert,can you help?

We sincerely invite you to subscribe to the Invite Answer email!

If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.

Help others and be happier!

  • Subscribe

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.Specific people will also have their own exclusive badge.
CEO Badge

The CEO Badge is owned only by the boss of Banggood.

Badges you can earn are coming soon
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe