Answers

Johan I believe that the Ender-3 V2 already have this board, the biggest problem with this is that it's not able to handle Linear Advanced.

Helpful (0)
Submit
Answers (6)

Q: Is it possible to use this with a Prusia Clone with 2 z axes?

Asked by micim987 on 2019-06-25 19:38:32

Johan Just wire them in series and you are good. I have like this on my CR10 and on my TronXY X5S, both have closed loop belt connecting the two Z-screws and both work perfectly, I use BLTouch to get the Z hight in the middle and the leveling never change.

Helpful (1)
Submit
Answers (4)

Johan Asnyou can see, it's an Ender-3 Pro inside so I figure it will fit okay.

Helpful (3)
Submit
Answers (2)