Answers

Q: boa tarde!!! esse valor se refere 2 peças 2 porta pinça?

Asked by BG411041450 on 2022-07-09 12:52:24

PawlakCNC umape a - h 2 na foto porque voc pode escolher ER11 ou ER16

Helpful (0)
Submit
Answers (1)

Q: Do you have istructions?

Asked by a.iannuzzi on 2018-02-15 03:33:02

PawlakCNC R421A088 przekaźników po Modbus RS485 Description of the board control: The designation 0x0 means that the entry is hex in brackets gives the values

Helpful (0)
Submit
Answers (2)

Q: these are carbide or hss endmill?

Asked by BG433943453 on 2022-04-05 16:13:45

PawlakCNC theseare carbide

Helpful (1)
Submit
Answers (1)

PawlakCNC Thisis normal I also have in Chinese - use google translator in the phone

Helpful (0)
Submit
Answers (1)

PawlakCNC generatedwaveforms: waveforms: sine wave, square wave, triangular wave, Lorentz pulses, white Gauss noise, modulated - modulation of FM and AM signal

Helpful (0)
Submit
Answers (2)

PawlakCNC I started testing the MDS8207 multimeter and found some factory defects. After entering the TIME mode under the F4 button there is no POS option and related functions After stopping the waveform (HOLD or Single) under Kalisz F4 there are no CURS and related functions (button F4 works because it makes a sound but the option is invisible and does not react) there is an error in the manual, the "AUTO OFF" function turns off without holding R a F1 and the mute is not mentioned and the mute option is under F4 The disadvantages are serious and result from an error in the device's software - I checked other reviews on the Internet and all devices have this disadvantage - the manufacturer should fix it as soon as possible and sold stings replace or provide a corrected soft with instructions for its installation. The situation is a bit like the car manufacturer forgot to mount a gear with reverse gear - the car is like a department, but it is not fully functional and does not comply with the specification.

Helpful (13)
Submit
Answers (10)