Customer Reviews

4.86 out of 5
See all 252 reviews
Write a Review
  • All Reviews (252)
  • Image (28)
  • Video (0)
  • All Star
    • All Star(252)
    • 5 Star(232)
    • 4 Star(11)
    • 3 Star(5)
    • 2 Star(1)
    • 1 Star(3)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (Australia)
|
Show Original

A part of the review has been auto-translated.

  • 31/07/2021

    i have not tested yet but arrived in very good condition!!!

    Comments (1)
    Show Original
  • 12/01/2022

    excellent quality working good

    Comments
    Show Original
  • 26/08/2021

    Fast delivery, good product!.

    Comments
    Show Original
  • 20/10/2021

    Unfortunately, the device was charged without any protection and was wrapped in a plastic bag, causing some parts to be damaged. To be honest, the shipping speed was good and the order arrived in about two weeks.

    Comments
    Show Original
  • 25/02/2020

    I’ve been unable to make it work when it is directly plugged on my UNO clone. However it works perfectly when I use the Rx, Tx and Gnd pins from the UART under the Status and NetLight LEDs (as shown in picture). For my project it’s okay, but could be a problem if you want the shield to be stacked. In addition it’s clearly not brand new... but hey, at this price point I can’t complain since it’s working!

    Comments
    Show Original
  • 26/08/2018

    Well it came very fast,like 7-8 working days. (location Greece) The package was in a good condition and the shield itself also. I havent tested it yet but I dont see any damage.

    Comments (1)
    Show Original
  • 09/12/2019

    Like on the description, delivery was fast, i am happy about it. I did not yet try it. Just a pity there is not the male pins to plug the shield directly on the arduino

    Comments
    Show Original
  • 23/12/2016

    Recibido hoy después de casi 1 mes con envio priority, todavia no lo he probado dado que se necesita una pila CR1220 (En cualquier tienda creo que las encuentras) tiene buena calidad veremos que tal funciona.

    Comments
    Show Original
  • 09/02/2017

    the DC-DC converter MIC29302WU on the board has 5 pins and uses about 7mA in standby. I cut all traces to pin 1 and 2 and connected pin 2 to RAW and pin 1 to an unused port. so i can shut down the DC-DC converter completely. HIGH on pin1: MIC29302WU working LOW on pin1: MIC29302WU shut down, no current use! best wishes from austria

    Comments
    Show Original
  • 06/12/2015

    Works perfect. Writing a working sketch in arduino is a little bit more difficult because libraries found online doesn't work with this module. You must make your own library or sketch from beginning.

    Comments (1)
    Show Original
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • US$10.99
    • US$6.99
    • US$10.99
    • US$24.23
    • US$32.99
    • US$4.18
    • US$13.52
    • US$5.99
    • US$7.39
    • US$9.01
    • US$6.99
    • US$29.99
    • US$8.99
    • US$7.99
    • US$29.99
    • US$7.99
    • US$3.99
    • US$9.99