SANOU Outside Jaws For 3 Jaw Lathe Chuck K11-80 80mm Self Centering Chuck Jaw Foot
A part of the review has been auto-translated.
If you have EINHELL BT-ML300 it will work well. Check the numbering when mounting.
К патрону на 80 мм подходят идеально. Номер у всех кулачков одинаковый. Прилегание кулачков плотное но растачивать все равно прийдется.
The original delivery unfortunately arrived faulty from France and was immediately complained: Spannjawe No. 3 was double, the No. 1 was missing for it. After some e-mails, however, a replacement was delivered to me. They are hard jaws, which should be taken into account when using them. They run perfectly and without play. Used in a 300er single jaw with 80er lining.
These fitted my 8 year old 80mm 3 jaw chuck, on an Axminster / Sieg C2 lathe. The chuck bears the name 'Tian Pai'.on a sticker. I obtained the lathe second hand with no outside jaws for the chuck. The run out using a 12 mm drill is acceptable (without any tweaking) at 2.5 thousandths inch, I suspect de-burring the sharp edges on the new jaws, and bumping the chuck run out could be used to reduce the over all runout. Very pleased with my decision to take the risk much cheaper than a new chuck. I can't guarantee that they will fit your chuck, check the measurements given carefully against you own inside chuck jaws as I did.
At the first delivery unfortunately 2x clamps jaw number 1 delivered, thus unusable. The clamping jaws themselves are hard jaws and are made clean.
Thank you, I got it. The quality is low, but the cartridge got up normally. Bought for sawing and experimenting, so overall satisfied.
Perfetto!
Precies de juiste maat buitenbekken voor een ander merk klauwplaat. Ik ben helemaal blij.
Tovar došil v poriadku
Exactly as discribed.Fits perfect on my mini lathe.A sale well done.Thank you.