Customer Reviews

4.65 out of 5
See all 20 reviews
Write a Review
  • All Reviews (20)
  • Image (2)
  • Video (0)
  • All Star
    • All Star(20)
    • 5 Star(15)
    • 4 Star(3)
    • 3 Star(2)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (Australia)
|
Show Original

A part of the review has been auto-translated.

  • 24/01/2022

    this car is a blast to drive around with, but the build process was cumbersome, and not without problems. My only real complaint is that the metal rods were not threaded properly in my kit. They LOOKED like they were, but under a microscope I determined that were rolled, but not threaded, so no amount of turning would get the rod ends to thread down over them. I had to force them on and it was miserable. Installing the LED's was a bit of a chore. The spots you are expected to place them don't fit them well, but drilling out those spots with a small drill made them nestle in place much better. . Wire management sucked because I couldn't get CA glue to stick to the plastic coating on the tiny little wires. I used thread to "zip tie" them to the frame and glued that instead which worked great. Did I mention there is ZERO ROOM inside of this thing? its impossible to work on it while the motor is in place. the roll cage completely blocks access to everything within. They really should make the top half of the cage detachable in order to work inside, and then just screw it down when you are done. I ended up removing a lot of it. The main controller board could be a LOT smaller without sacrificing functionality. If I ran the world, things would be done differently... Also, they expect you to thread those tiny little ball joints into the untapped plastic with a tiny little Allen wrench, but its nearly impossible. I cut the 0.9mm Allen wrench in half and used a pin vice to hold the straight part so I could use it like a screwdriver. all in all, once it is built, this thing is loads of fun. I put an FPV camera on it and drive it all over the office building. You should too! I am going to buy a second one to build a little differently. :)

    Comments (1)
    Show Original
  • 12/05/2021

    can't wait to finish building this. I did notice some of the holes in pieces are not all the way through. ill end up selling through to clean up the holes. really cool kit though. I'll edit my review with photos when done

    Comments
    Show Original
  • 17/08/2023

    Arrived earlier than expected, it is very entertaining to assemble, although a bit complicated to weld the lights. Super recommended.

    Comments
    Show Original
  • 19/01/2022

    Whoever designed this is crazy. It's basically a 1/32 scale down of the 1/10 scale! Damn tiny parts but all the details are there! Eventually I put in a 300rpm motor on this for slow crawling https://www.youtube.com/watch?v=TX974ANkuyI

    Comments (1)
    Show Original
  • 21/10/2021

    Super kit. Just something for skillful hands.

    Comments
    Show Original
  • 13/01/2021

    yes I received my truck . and costumer service was the best for helping change my order so I could buy the same truck as a ready to run . thank you

    Comments
    Show Original
  • 15/12/2023

    Nice Product. Fast Shipping. Thank you!

    Comments
    Show Original
  • 09/12/2023

    Fun little car to drive around the office desktop

    Comments
    Show Original
  • 01/01/2022

    excellent product

    Comments
    Show Original
  • 12/10/2021

    very good quality

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • US$369.99
    • US$475.99
    • US$48.99
    • US$106.99
    • US$24.99
    • US$110.99
    • US$107.99
    • US$76.99
    • US$272.99
    • US$49.99
    • US$189.99
    • US$166.99
    • US$103.99
    • US$38.99
    • US$90.99
    • US$73.99
    • US$105.99
    • US$146.99