Customer Reviews

4.89 out of 5
Write a Review
  • All Reviews (18)
  • Image (2)
  • Video (0)
  • All Star
    • All Star(18)
    • 5 Star(16)
    • 4 Star(2)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
  • 2020-01-24 09:15:30

    Arrived safe and sound. First impressions were luke warm as the board look tatty, but it was just unwashed flux. There is a handy arrow ti assist you in getting the ESP01s plugged in the right way around, and be careful it is very easy to get wrong. To use it as a programer for the Arduino IDE, all you need to do is add a simple switch between IO0 and GND to get it in to flash mode. Simple.

    Comments
  • 2018-09-11 16:16:25

    For this Programmer the ESP-Module has to be placed outwards. For me the standard DTR/CTS control for programming is not working using Arduino IDE! First of all I had to solder a pullup resistor between VCC and the CD_PD pin. To put the ESP-01 in programming mode GPIO has to be pulled to ground (soldered a jumper to the pin) followed by pressing the Reset button. For Nral opreation the Jumper should be removed again.

    Comments (3)
  • 2020-07-01 12:49:35

    arrived in good conditions

    Comments
  • Adri
    BE
    2020-06-19 10:44:54

    Fait le job

    Comments
  • flyfons
    IT
    2020-04-17 10:36:18

    Utile per esp01s

    Comments
  • 2020-04-03 10:00:15

    GOOD ITEMS

    Comments
  • Daniele
    IT
    2020-01-13 14:19:13

    ok

    Comments
  • mosheb3
    IL
    2019-12-03 02:21:53

    Good product

    Comments
  • Jesper
    DK
    2019-11-07 14:11:35

    All good

    Comments
  • Kamil
    SK
    2018-04-25 13:49:32

    I plan to use this adapter for ESP 8266 - 01. It looks OK, but there are missing any instructions. I have found driver on internet, so the driver in my PC is OK. Adapter itself could be OK, there is 5V to 3.3V conversion, but I was not able to upload software to ESP 01 board. Missing switch GPIO0 to GND (for software upload). My ESP01 module was not S type, so maybe this was a problem.

    Comments (2)
Show:

    Go to page

    Go

    You might be interested in

    recommendation for you
    • AU$5.13
    • AU$4.31
    • AU$4.31
    • AU$7.73
    • AU$2.45
    • AU$20.18
    • AU$4.31
    • AU$5.75
    • AU$6.04
    • AU$4.31
    • AU$4.31
    • AU$15.85
    • AU$2.29
    • AU$2.87
    • AU$4.01
    • AU$2.87
    • AU$5.32
    • AU$20.18