Banggood

UNA PIEZA MECÁNICA DE ALUMÍNIO BASTANTE EFICIENTE. SÓLO UNA COSA, LA HARÍA FALTA UN MUELLE PARA AMORTIGUAR LA FUERZA DEL SERVO AL CERRAR LA PINZA. SI EL SERVO TIENE MÁS RECORRIDO QUE LA PINZA SE PUEDE DAÑAR.

good very good

ok

ok

The one received is not the same I asked for. The claw is different (see picture), but It's Ok for me. I have another one (picture comparation). The old one is lighter but when placing the servo on it,it becomes unbalanced. This gripper is a bit bigger and heavier than my old one but at least it is balanced.

It's much bigger than I think !! work fine, not bad build. I use it with this servo: https://www.banggood.com/MG995-High-Torgue-Mental-Gear-Analog-Servo-p-73885.html?p=5G2717320323201310AJ

Very similar to the one pictured but the fingers came with large pads instead of the textured tines like the picture suggested. Still a decent gripper. I took the pads off the fingers and am using it as is.

I purchased 2 of these metal grippers, they where larger then I expected but I'm very pleased with them. I use them in combination with the PDI-6221MG and they can put out some real force.

Nice gripper for my rob. working with MG995. Size: open: wide=45mm, length=40, close: length(overall)=120mm.

état impeccable