Customer Reviews

5 out of 5
See all 27 reviews
Write a Review
  • All Reviews (27)
  • Image (6)
  • Video (0)
  • All Star
    • All Star(27)
    • 5 Star(27)
    • 4 Star(0)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (Australia)
|
Show Original

A part of the review has been auto-translated.

  • 28/01/2021

    looks good and feels good,in my hands. I have. to wired it up yet instructions was on one piece of paper with no examples (see photo). the attached cable is about 6 foot but will stretch further.

    Comments
    Show Original
  • 27/07/2021

    Thanks for Fast delivery and safe delivery. it work fine so I am happy.

    Comments
    Show Original
  • 07/12/2019

    Dieser Artikel hat kein -A -B am Drehrad. so musste ich mich zu helfen wissen und habe kurzerhand einen mit 6 Anschlüssen umgebaut. Da meine CNC Anlage nicht mit 4 Anschlüsse läuft.

    Comments (1)
    Show Original
  • 29/09/2019

    very very good product

    Comments
    Show Original
  • 01/07/2019

    nice product only mistake in connection details

    Comments
    Show Original
  • 25/03/2018

    i reconnecting inside wires because thees not like paper shows now it works well

    Comments
    Show Original
  • 21/04/2021

    Looks Ok. Not tested yet.

    Comments
    Show Original
  • 21/10/2020

    RAS compliant product. Attention the notice is not in English

    Comments
    Show Original
  • 29/01/2019

    Good Product , But there is a catch ,you need to check all the wiring inside the control Box of the MPG ,the first one I have ordered there where 3 wires that was not welded at all because they broke of the connector on the mpg even if there where glued with hot melted glue , I will have to open this one to be sure before connecting to my Second CNC controller and by the way I could not change the star Rating because I would have given only 4 stars

    Comments (1)
    Show Original
  • 14/02/2018

    Back casing made from cast aluminum and plastic on the front section. As described. Holds well in the hand. Lisible dial enscription. Precise movement of all buttons.The E Stop button is a bit flimsy. There are a ton of wire at the end, wich is not shown. So be patient when you will get to hook it up to your break out board!!!

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • AU$554.73
    • AU$69.63
    • AU$235.33
    • AU$222.14
    • AU$69.63
    • AU$65.86
    • AU$9.18
    • AU$10.71
    • AU$4.58
    • AU$68.20
    • AU$18.09
    • AU$131.74
    • AU$9.18
    • AU$69.63
    • AU$6.48
    • AU$3.23
    • AU$7.16
    • AU$50.13