Customer Reviews

5 out of 5
See all 57 reviews
Write a Review
  • All Reviews (57)
  • Image (8)
  • Video (0)
  • All Star
    • All Star(57)
    • 5 Star(57)
    • 4 Star(0)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (Australia)
|
Show Original

A part of the review has been auto-translated.

  • 11/07/2021

    This programmer is its money worth, easy way to program the esp for the first time. I'am using tasmota firmware, so the upgrafes are OTA. Happy I bought this one, after always messing around with programming.

    Comments
    Show Original
  • 20/11/2020

    Looks great support ESP01 and ESP12 modules. Except DC converter to 3.3V in small case. Unsure that its enough for debuging with coil relay.

    Comments (1)
    Show Original
  • 15/04/2021

    Very nice board. Works as expected. It needs a good quality usb data cable.

    Comments
    Show Original
  • 17/12/2020

    gud

    Comments
    Show Original
  • 02/03/2021

    Seems to be a useful board for programming and testing. I have not tried it yet.

    Comments
    Show Original
  • 10/07/2020

    Burning Board works flawless. as it uses a ch340 usb serial IC i didnt Need any new driver. just plugged it in, startet esp Flashing software and startet burning a Firmware. i can recommend it if you have bulk esp baords!!!

    Comments
    Show Original
  • 13/09/2020

    Nice. Recommended

    Comments
    Show Original
  • 10/08/2020

    Super best quality! Beautiful thing

    Comments
    Show Original
  • 22/02/2021

    I can see why this board gets good ratings. Worked first time...well technically it didn't because I did not know how to use it :) 1) Push the power button till the red light is out. 2) Plug in your ESP, gently push down, lining all the pins up, and it actually stays held in place. 3) Find the USB port number on your Arduino IDE 4) program as normal, no need to push reset etc. 5) push the power button to turn off the power. 6) there is a cutout on the main PCB holder that you can use to push the chip out(Gently) As a bonus, this can program the ESP-01 I am glad I paid that bit extra to get this unit, as the quality and function is very good.

    Comments (1)
    Show Original
  • 31/07/2021

    VERY nice board. Took me a bit to program an ESP8266 with Arduino IDE. Choose 'Generic ESP8266 Module', upload 115200, 80MHz, 1M xxSPIFFS, DIO, 40MHz, reset: nodemcu (some other settings might also work - but this is my setup) 1. press and hold the reset button 2. press and hold the program button 3. release the reset button, the ESP will boot in program mode 4. release the program button 5. upload the sketch

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • AU$11.15
    • AU$11.15
    • AU$11.84
    • AU$5.57
    • AU$12.54
    • AU$13.94
    • AU$5.57
    • AU$9.75
    • AU$5.57
    • AU$111.59