Bought this and did some homework on how to best waterproof ESC etc. This is only my opinion and experience and by no means 100% waterproofing can be attained. For all servos, I spread silicone grease on them. For the ESC, find a spot at the bottom of the cockpit so if your plane flips, it will be the last thing to get soaked. Furthermore, I used a non-corrosive silicone sealant from hardware store to seal each end of the ESC that wasn't covered in the rubber shrink. My receiver was contained in a balloon and then wrapped in bubble wrap. Once the wings were attached, I used Blenderm surgical tape to seal off crevices between wing and where it's mounted. I also used same tape to seal off any exposed parts of the fuselage that could possibly take in water during taxing. Last, I sprayed CorrosionX in the motor.

Bought this and did some homework on how to best waterproof ESC etc. This is only my opinion and experience and by no means 100% waterproofing can be attained. For all servos, I spread silicone grease on them. For the ESC, find a spot at the bottom of the cockpit so if your plane flips, it will be the last thing to get soaked. Furthermore, I used a non-corrosive silicone sealant from hardware store to seal each end of the ESC that wasn't covered in the rubber shrink. My receiver was contained in a balloon and then wrapped in bubble wrap. Once the wings were attached, I used Blenderm surgical tape to seal off crevices between wing and where it's mounted. I also used same tape to seal off any exposed parts of the fuselage that could possibly take in water during taxing. Last, I sprayed CorrosionX in the motor.

Bought this and did some homework on how to best waterproof ESC etc. This is only my opinion and experience and by no means 100% waterproofing can be attained. For all servos, I spread silicone grease on them. For the ESC, find a spot at the bottom of the cockpit so if your plane flips, it will be the last thing to get soaked. Furthermore, I used a non-corrosive silicone sealant from hardware store to seal each end of the ESC that wasn't covered in the rubber shrink. My receiver was contained in a balloon and then wrapped in bubble wrap. Once the wings were attached, I used Blenderm surgical tape to seal off crevices between wing and where it's mounted. I also used same tape to seal off any exposed parts of the fuselage that could possibly take in water during taxing. Last, I sprayed CorrosionX in the motor.

I did not receive a propeller with this purchase, one is supposed to be included, how does this get fixed? How will one be sent to me?

I did not receive a propeller with this purchase, one is supposed to be included, how does this get fixed? How will one be sent to me?

I did not receive a propeller with this purchase, one is supposed to be included, how does this get fixed? How will one be sent to me?