MCU: STM32F722 IMU: MPU6000 USB: Type-C Baro: BMP280 (I2C) OSD: BetaFlight OSD w/ AT7456E chip BLE: Support, used for Flight Controller configuration WiFi: Support, used for data transfer, e.g firmware flashing, and Blackbox analysis. DJI Air Unit slot: A full DJI Air Unit JST slot onboard BlackBox: 16MB onboard dataflash Current Sensor: 1 : 10 (Scale 168) BetaFlight Camera Control Pad: Yes Power input: 3S - 6S Lipo 5V power output 7 * 5V output, 6 pads and a BZ+ pad used for Buzzer, the maximum load current is 2.5A. 9V * 1, the maximum load current is 2.5A. 9V power output 2 * 9V output, 1 pads and another one used for DJI slot 4.5V power output: 1 * 4.5V output pad 3.3V power output: 1 * 3.3V output pad, the maximum load current is 500mA. ESC signal: M1 - M4 UART: Full UART * 5(UART1, UART2, UART3, UART5, UART6) ESC Telemetry UART: UART4 RX I2C: Used for external Magnetometer, Sonar, etc. LED pin Used for WS2812 LED Buzzer: BZ+ and BZ- pad used for 5V Buzzer Boot button: Used to easy enter DFU mode RSSI input: RSSI input solder pad SmartPort: Use any TX pad of UART for the SmartPort feature. Support Flight Controller Firmware: BetaFlight(Default), EMUFlight Target name: SPEEDYBEEF7V2 Mounting: 30.5 x 30.5mm, 4mm hole size Dimension: 41 x 38 x 6.9mm Weight: 9g |